Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364LED10W-LTBATTERY SPECIFICATIONS 12 volt output 33 Amp hour AGM sealed lead acid Built-in automatic charger rated for continuous duty Voltage indicator gauge with push-to-test button External charge cord receptacle, U.S. or foreign power cord supplied Battery rated for 300+ full discharge cycles 3-5 year estimated service life 1 year warrantySET-UP1. Charge unit for 24 hours when new and every three months thereafter to maintain a fullcharge (Charge monthly in hot weather)2. Do not charge or use this light in hazardous location3. Extend retractable legs if necessary for uneven terrain4. Extend aluminum pole to desired height and tighten each pole section into positionOPERATION1. Single head light will operate over 40 hours on a full charge2. Dual head light will operate over 20 hours on a full charge3. The power port provided can be used to operate a cell phone, a laptop computer, or anyof Larson Electronics’ handheld light with cigarette plug. The power port can be used asa quick charge inlet for the light from an automobile’s 12-volt power port.SAFETY AND USAGE INFORMATION1. Read these instructions completely before using the products and save them for futurereference.2. Do not use unit to recharge dry cell batteries3. Do not jump-start or attempt to recharge a frozen battery.4. Charge unit in a well-ventilated area.5. All batteries are affected by temperature changes, and the unit’s small, lightweightbattery is more sensitive to storage temperature than a standard automotive battery.Temperatures above 68° F (20° C) decrease amperage output. The ideal storageenvironment for emergency use is at room temperature.