Larson Electronics LEDWL 1227 Series Instruction Manual

Also see for LEDWL 1227 Series: Instruction guide

Larson Electronics LEDWL 1227 Series Instruction Manual Manual pdf 1 page image

LEDWL-xx-1227Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 2LEDWL-RED-1227 Instruction Guide25W Colored LED Warning SpotlightThank you for your purchase of the Larson Electronics LEDWL-xx-1227 series LED spotlight. This light iscompletely assembled, tested and ready for installation when shipped from the factory. Please follow the stepsbelow in order to operate and maintain this product.IMPORTANTREAD CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTUREREFERENCE. IF UNSURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICALPROFESSIONAL.WARNING: OPERATE ONLY AT THE VOLTAGE LISTED ON THE PRODUCT. DO NOT OPERATE IN CLOSEPROXIMITY OF COMBUSTIBLE OR FLAMMABLE MATERIALS. NEVER LOOK DIRECTLY AT LIGHT WHEN ON. DONOT SHINE LIGHT INTO THE FACE OF SOMEONE ELSE.WARNING: CONSULT A QUALIFIED ELECTRICAL PROFESSIONAL/ELECTRICIAN TO INSTALL THIS DEVICE INACCORDANCE WITH APPROPRIATE LOCAL AND NEC CODES AND REGULATIONS.WARNING: DEVICE IS SUITABLE FOR INSTALLATION IN WET LOCATIONS; GFCI PROTECTIONRECOMMENDED.WARNING: ALTHOUGH FIXTURE IS WATERPROOF, IT IS NOT DESIGNED OR INTENDED TO BE SUBMERGED.WARNING: DO NOT ALLOW LINE VOLTAGE WIRES TO BECOME SUBMERGED!• IP67 RATED; SUITABLE FOR WET LOCATIONS (ALTHOUGH FIXTURE IS WATERPROOF, IT IS NOTDESIGNED OR INTENDED TO BE SUBMERGED).• ALL OUTDOOR INSTALLATIONS AND INDOOR INSTALLATIONS NEAR A WET LOCATION REQUIRE THEUSE OF A GFCI DEVICE FOR SAFETY, ACCORDING TO THE NATIONAL ELECTRICAL CODE® (NEC).• KEEP AWAY FROM FLAMMABLE OBJECTS. DO NOT POSITION WITHIN ONE (1) INCH OF ANYCOMBUSTIBLE MATERIALS.• IF DROPPED OR DAMAGED, THE UNIT MAY NO LONGER BE WATERPROOF AND SHOULD BEREPLACED.• TO AVOID HAZARDS TO CHILDREN, ACCOUNT FOR ALL PARTS AND DESTROY PACKING MATERIALS.INSTALLATIONMOUNTINGMount via the U-bracket style trunnion mount. Find a suitable locationsturdy enough to support the light. Drill a single ½-inch through hole tobolt the light to. A single bolt protrudes from the bottom allowing the LEDlight to be mounted to surfaces using a single ½-inch through hole.WIRINGOnce mounted, check to ensure the deutsch connector from the transformer is plugged into the back of thelight. Run cord and transformer near power source. Wire the transformer into the proper voltage listed on itsproduct label. Improper voltage could cause the unit to fail, voiding warranty. The light is “instant-on” and willturn on once power is supplied.Voltage: 120-240V AC DEUTSCH CONNECTORTRANSFORMER

/ 2

Related manuals for Larson Electronics LEDWL 1227 Series