Larson Electronics WAL-BP-3XLED-CPR Operation Manual

Larson Electronics WAL-BP-3XLED-CPR Operation Manual Manual pdf 1 page image

WAL-BP-3XLED-CPRLarson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 2108W Portable Emergency LED Light Tower10,000 Lumens - USB Port & 12V Socket - 5.25' Tall TowerOperation ManualSETUP PROCEDURE1. Lay case on ground and open lid.2. Deploy legs by releasing latch and rotating leg out. Lift the locking pin for holding leg in place.Once leg is aligned with locking pin, press pin down to engage.3. Repeat for leg on opposite side.4. Stand the light tower upright until it locks in place.5. Loosen adjustment knob and rotate light head upwards.6. Extend the light pole to the desired height by unlatching clips for each pole. Relatch clips to secureeach section.7. Unfold the light head and position lens up for spot light and down for flood light in one area. For allaround lighting, fold the light head to its 360° scene light configuration.8. Press the power button on the front to illuminate the light. 1 st Press – Low Output, 2nd Press – MediumOutput, 3rd Press – High Output, 4th Press – Off.9. Close the lid.BREAKDOWN PROCEDURE1. Turn light off by cycling through power button. (Additionally, light will automatically disengage oncefolded into case.)2. Fold and rotate light head downwards. Loosen adjustment screw and tighten.3. Open lid.4. Lower telescoping pole to its fully collapsed position.5. Fold light tower assembly into case by depressing the pin toward the base of the mast to unlock it andset it inside.6. Release locking pin holding each leg and fold toward case.7. Latch legs.8. Close lid and the light tower is ready for transport.CHARGING• Orange Receptacle marked “Input” on side is used for line voltage charging. This can be via thecigarette plug adapter or household 100-240V AC power supply. Connect either into Orange plugconnector and supply power to charge the battery.POWERING• A waterproof power button is located on the front to power the light. Next to the power button is agauge which displays the current battery levels.DC POWER RECEPTACLE• The light is equipped with 2 USB ports and a locking DC accessory receptacle, located toward thecenter top of the case accessed from inside the box under the lid. Simply plug devices into theseports for powering.VEHICLE EXTERNAL POWER SOURCE1. Attach DC power cord charger into the “Input” side of the light tower.2. Plug the DC power cord into the DC accessory receptacle of your vehicle.3. It is recommended that the vehicle be running during operation in this mode as it will drain the vehiclebattery. The light DC accessory receptacle is connected directly to the internal battery. NOTE:

/ 2

Related manuals for Larson Electronics WAL-BP-3XLED-CPR