Larson Electronics WALTP-Q500 Instruction Manual

Larson Electronics WALTP-Q500 Instruction Manual Manual pdf 1 page image

WALTP-Q500Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 2Telescoping Light Tower w/ Dual Remote Control SpotlightsInstruction ManualDo not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within thisinstruction sheet. Read carefully before operating. Retain these instructions for future reference.WARNING: Read all instructions carefullySAVE THESE INSTRUCTIONSCAUTION: RISK OF ELECTRICAL SHOCK• Do not use with extension cord near water orwhere water may accumulate.• Keep plugs and receptacles dry.• For use only on GFCI protected circuits.• Risk of burns, do not operate without lens.• Lighted lamp is hot. Keep away fromcombustibles. Unplug to change bulb. Do nottouch bulb.WARNING RISK OF FIRE, ELECTRIC SHOCK,EXPOSURE.TO EXCESSIVE UV RADIATION OR INJURY TOPERSONS• Unit operates on 120V AC 50/60 Hz only• Unplug and allow cooling before replacing bulb.• Bulb gets HOT quickly• Do not touch hot lens guard or enclosure.• Do not remain in light if skin feels warm.• Do not look directly at lighted lamp.• Keep lamp away from materials that may bum.• Do not touch the bulb at any time; use a softcloth or gloves. Oil from skin may damage bulb.• Do not operate the lamp with missing ordamaged guard, lamp containment barrier orUV light filter.USING THE TRIPOD1. To assemble the tripod, begin by loosening the black adjustment knob on thetripod base. Slide the center pole through the adjustment sleeve until the legsare fully deployed. Tighten adjustment knob so legs stay fixed in place. Nowyou are ready to install top portion.2. Position light head over top pole on tripod and tighten black adjustment knobuntil snug.3. Connect all Deutsch connections from cable to lights.4. Loosen black adjustment knob for each sleeve to extend tripod. Extend toppole, then bottom pole when elevating.5. Tighten adjustment knob once desired height is achieved. The switchposition can also be adjusted with the hand screw on the back.6. Attach power cord to Voltage: 120 VAC.OPERATIONThe light head features a 500 watt quartz work light. Power is controlled via thepower switch on back of light. Do not look directly into lights when powering.Lamp can be adjusted independently with the adjustment screws on the sides.Tighten screws once desired angle is achieved.BULB INSTALLATION AND REPLACEMENT (DO NOT TOUCH BULBWITH BARE HANDS)Allow lamp to cool prior to maintenance!1. Turn the light off and unplug from the power source.2. Allow the fixture to fully cool before proceeding.3. Always wear gloves or use a clean cloth to handle bulb. The natural oil from skinwill leave a residue that will cause the light to burn out immediately.4. To remove the lens cover, remove the retaining screw on the back of the lenscover. The lens cover will then swing open exposing the bulb.WARNING: CHECK NAMEPLATE FOR PROPER VOLTAGE. DAMAGEFROM IMPROPER VOLTAGE WILL VOID WARRANTY.- Light HeadAdjustmentPoints-Leg Sleeve

/ 2

Related manuals for Larson Electronics WALTP-Q500