Lastolite Cubelite Setting-up Manual
Also see for Cubelite: Operating instructions
   |
1. Remove items from the box. You should have:- Bag containing the Studio Cubelite (flat)- 4 x Black support rods- 4 x Silver support rods- Circular acrylic sheet- Roll of translucent filmRemove the Studio Cubelite from the protective bag.2. Lay the Studio Cubelite on the floor and position theend of one of the black rods on the corner of the lowersteel rim. Ensure the steel rim locates into the jaws ofthe tip at the end of the rod.3. Pull the middle and top steel rims away from the lowersteel rim and locate the jaws of the tip at the other endof the black rod into the middle rim.4. Repeat steps 2&3 for the remaining three corners.When all four rods are in place, check they are all in avertical position.5. Position the end of one of the silver rods on the cornerof the middle steel rim. Ensure the steel rim locatesinto the jaws of the tip at the end of the rod.6. Pull the middle and top steel rims away from eachother and locate the jaws of the tip at the other end ofthe silver rod into the top rim. This process will requiremore force than you used when positioning the blackrods, as they are a much tighter fit. This helps pull outthe crease in the white fabric.7. Repeat steps 5&6 for the remaining three corners.When all four rods are in place, check they are all in avertical position.8. Remove the blue protective film and place the circularacrylic sheet inside the top white section and place iton the white fabric surface seperating the top andbottom sections (do not drop this sheet as it will break).9. Place the translucent film inside the top white sectionof the Studio Cubelite. There is a velcro strip runningalong one edge of the film.10. Attach the velcro edge of the translucent film to thethe two velcro tabs already sewn into the top of thewhite section.11. The Studio Cubelite is ready to use. Add to it yourchosen lighting solution. Refer to the label near therear opening of the Studio Cubelite for advice onhow to position the light source inside.Breaking Down your Studio Cubelite12. Remove the translucent film, roll it up and return it tothe protective tube.13. Remove and pack away your chosen lighting system.14. Remove the circular acrylic sheet from the top of thelower unit and return it to the protective bag.15. Remove the supporting rods from the top section thenthe lower section and allow the three steel rims to lieon top of each other. Return them to the protective bag.16. Return all the Studio Cubelite items to the storage box.Setting up your Studio Cubelite1 2 34 5 67 8 910 11B90371 - page 1 of 3 |
Related manuals for Lastolite Cubelite
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine