Lava LG-837 Use And Care Instruction Manual
  |
When using electrical appliances, especially whenchildren are present, basic safety precautions shouldalways be followed, including the following:Read all instRuctions befoRe using.KeeP aWaY fRoM WateR.dangeR -As with most electrical appliances, electrical partsare electrically live even when the switch is off.to reduce the risk of death by electrical shock:1. Always "unplug it" immediately after using.2. do not use while bathing.3. do not place or store appliance where it can fallor be pulled into tub or sink.4. do not place in or drop into water or other liquid.5. If an appliance falls into water, "unplug it" immediatelydo not reach into the water.WaRning -to reduce the risk of burns, electrocution,fire, or injury to persons:1. An appliance should never be left unattendedwhen plugged in.2. Close supervision is necessary when thisappliance is used by, on, or near children or individualswith certain disabilities.3. Use this appliance only for its intended use as describedin this manual. do not use attachments notrecommended by the manufacturer.4. Never operate this appliance if it has a damaged cord orplug, if it is not working properly, if it has been droppedor damaged in any manner or dropped into water.Return the appliance to a service center for examinationand repair.5. Keep the cord away from heated surfaces.do not wrap the cord around the appliance.6. never block the air openings of the appliance or placeit on a soft surface, such as a bed or couch, where theair openings may be blocked. Keep the air openings freeof lint, hair, and the like.7. never use while sleeping.8. never drop or insert any object into any opening or hose.9. do not use outdoors or operate where aerosol (spray)products are being used or where oxygen isbeing administered.10. do not use an extension cord with this appliance.11. do not direct hot air toward eyes or otherheat-sensitive areas.iMPoRtant safetYinstRuctionssaVe tHeseinstRuctionsoPeRating instRuctionsThis appliance is intended for household use.This appliance has a polarized plug (one blade is wider than theother). As a safety feature, this plug will fit in a polarized outletone way. If the plug does not fit fully in the outlet, reverse theplug. If it still does not fit, contact a qualified electrician. Do notattempt to defeat this safety feature.sHocK PRotection Plug (alci)This hair dryer includes an Appliance Leakage Current Interrupter(ALCI) plug for your safety.Should abnormal conditions be detected or if the applianceis immersed in water the safety plug will trigger and shut theappliance off.test alci befoRe eacH use• Plug ALCI into AC electrical outlet (ordinary householdcurrent only)• Press the TEST button, if appliance was on it should stopimmediately and the RESET button should pop out.(This confirms proper safety plug operation)• To resume use press the RESET button.(see diagram below)• If the safety plug test fails or if the appliance is immersedreturn it immediately for service as instructed inthe warranty.useR Maintenance instRuctionsMaintenanceThis appliance requires no special user maintenance orlubrication. Should your dryer require cleaning, unplug it firstthen simply wipe the outer housing with a damp cloth.Clean the air intake grille periodically using a soft bristle brush toavoid dust and lint from accumulating.Each time you use the appliance untwist the cord to avoidtangling and internal damage.WaRning: If this appliance malfunctions do not attempt torepair it yourself. This appliance has no user serviceable parts.stoRageAfter each use unplug the appliance and let it cool; store ina clean, dry place. Never store it while still hot or pluggedinto an outlet.Never wrap the cord tightly around the unit. do not hang theappliance by the power cord and avoid pulling or strainingespecially at the point where it enters the unit and at theplug connection.12. Attachments may be hot during use. Allow themto cool before handling.13. do not place appliance on any surface while it is operating.14. While using the appliance, keep your hair away fromthe air inlets.16. Be sure dual-voltage selector is in correct voltage positionbefore operating. Before plugging in, read the informationabout dual voltage contained in the instruction sectionof this manual.17. This appliance was set at the factory to operateat 125 volts. Refer to operating instructions sectionof this manual for conversion to 250 volts operation.iMPoRtant: This appliance is designed with an automaticthermal limiter which will cycle off when the dryer is over heatedand come back on when cooled down. This may occur whenthe air intake or exit openings are partially blocked. Should thisoccur turn the dryer off, clear any blockage and clean the airintake screen. Allow dryer to cool for a few minutes and return tonormal operation.caution: do not block the air intake or outlet openingsor place the appliance down while it is operating.to add and ReMoVe attacHMents(see diagram a on other side)dRYing/stYling tiPs• Begin by towel drying hair to remove excess water.• For longer or thick hair, use the wide-tooth comb attachmentto untangle as you dry.• When hair is close to dry, select a lower heat and speedand use the fine-tooth or the brush attachments to smoothand style to your preference.• If you prefer not to use the attachments, separate hair intosections and start drying each section using the higherheat and speed settings. Be sure to continuously move thedryer and avoid directing airflow on any one area for anextended period of time.Test buttonReset buttondual Voltage instRuctionsBefore you attempt to change thevoltage setting, be sure the powerswitch is in the OFF position.For use in the U.S.A., the voltageselector switch should be placedin the 125 volt position. For use inseveral countries overseas, thevoltage selector may need to beplaced in the 250 volt position.Confirm the voltage available at eachoverseas location before using theappliance. For connection to a 250volt supply, use an attachment plug adapter of the properconfiguration for the power supply receptacle.To change the voltage use a screwdriver or coin and turn theselector so the arrow slot is pointing at the required voltage.When using at 250 volts, the appliance will only operate withthe switch in the “Low” position. At this setting the applianceis actually operating at “HI” speed and heat.do not try to use the appliance in the “HI” setting whenoperating at 250 volts.HiLowOff250V125VPOWER SWITCHVOLTAGE SELECTOR |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine