Lawler 911E Installation & Maintenance Manual

Also see for 911E: Installation & maintenance manual

Lawler 911E Installation & Maintenance Manual Manual pdf 1 page image

temperedwater.com5330 East 25th St.Indianapolis, IN 46218Phone (317) 261-1212Fax (317) 261-1208INSTALLATION &MAINTENANCE MANUALDesign and specifications subject to change without notice.Please refer to temperedwater.com to ensure mostcurrent data sheet and other design solutions.CAUTION: When maintaining and adjustingthe mixing valve, the delivered flushing fluidtemperature shall be 60°F (15°C) to 95°F (35°C).In circumstances where chemical reaction isaccelerated by flushing fluid temperature, a medicaladvisor should be consulted for the optimumtemperature for each application.CAUTION: When maintaining and adjusting themixing valve, all fixtures should be isolated fromuse. Lawler Manufacturing Co., Inc. recommendsthat you work safely at all times and in a mannerconsistent with the OSHA Lock/Tagout standard,29 CFR 1910.147 and other applicable standards.temperedwater.com/patentsENG. NO. 8429-AASSE 1071 ApprovedASSE Lead Free CertifiedNOTICE! No mixing valve will work satisfactorily if improperly installed. We suggest, therefore, that you readthese instructions carefully before installing and follow directions as outlined. Handle the mixing valve with care.Model 911 ®EThermostatic Mixing ValveEmergency ShowerThis installation & maintenance manual covers allconfigurations of the Model 911E.CAPACITIES – MODEL 911EPressure Drop PSI 5 10 20 30 45Tempered Flow GPM 9 13 17 25 27Tempered Flow LPM 34 49 64 94 102BYPASS CAPACITIES – MODEL 911EPressure Drop PSI 5 10 20 30 45Cold Bypass GPM 7 10 14 21 22Cold Bypass LPM 26 37 53 79 83Maximum Inlet Pressure: 125 PSIRecommended Supply Pressure: 65 PSIRecommended Inlet Temperature: 120°FWhen supplying 140°F or greater, additional outletcontrols should be used.Set Point: 85°FGallon per minute ratings may vary depending uponincoming water temperatures and pressures. Hot and coldwater inlet pressures must be equal.Valve must be installed with check valves. If shut off valvesare installed in the shower line for maintenance purposes,provisions shall be made to prevent unauthorized shut off.DIMENSIONSValve Number A N.P.T. B N.P.T. C D E911 1-1/4” 1-1/4” 6-1/2” 7” 5”Dimensions are for reference purposes only. For rough-in dimensionsplease refer to Lawler’s Revit/BIM models found at temperedwater.com.Allow for 3” depth.8429_911E_TH_DRW_NODIMS.pdfBCEA AD