FM transmitter & Coaster Pager User’s manualThank you for purchasing the“ LTK-P1200 transmitter & Guest paging system”.We are confident our cutting edge products and first rate service will satisfy your needs for yearsto come. Please read this these instructions carefully before setting up your Guest Paging system!EQUIPMENT SETUPKeypad Sending Unit:Unwrap all sending unit components. Lock the antenna into the hole in the upper right handCorner of the sending unit. Plug the power supply with the large tip into a standard 110 outletand plug it into the back of the sending unit. We recommend some type of surge suppressor onthe power supply for protection. Power surges are not covered under system warranty!Coaster Steup:Locate the black charging base in a sturdy, out of the way location. Connect the charger basestogether using the included jumper wires. Use the power- suppy with the small tip and plug itinto a standard 100 outlet and into either open plug on the charger base. Be sure to plug thejumpers & power supply jacks in all the way.Stack the coasters on the black charging base. The coaster number will always face front andthe red charge indicator light will be on the left.We recommend that you do not stack coasters more than 15 high.You should see a red light appear on each coaster. This light indicates proper charging istaking place.Coaster Numbers:On the front of each coaster is your coaster number*Smps adaptor (Transmitter Use: DC 12V 2.5A) , (Charger Base: DC12V 2.5A)