LumaPro 2LBL5 Operating Instructions And Parts Manual
    |
Model 2LBL5: 150 Watt High Pressure Sodium Security LightModel 2LBL6: 100 Watt Metal Halide Security Light598-1318-01NOTE: All wiring must be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through conduit oranother acceptable means. Contact a qualified electrician if there is any question as to the suitability of the system.1. Select a location on a flat wall with structurally sound wood andfrom 10 to 25 feet from the ground. The wood should be at leastone inch thick to safely secure the fixture.2. Attach the cover plate using two large machine screws.3. Using the mounting bracket as a template. Hold it at the desiredmounting location (making sure the bottom is level), and markfour mounting holes. We suggest drilling 3/16" pilot holes for thelag screws.4. Put the two top lag screws through their holes in the mountingbracket and hold them in place while you push the gasket ontothese lag screws. Start these two screws into the two top pilotholes.5. Start the other two lag screws, and then tighten all four screws.6. Hang the fixture on the mounting bracket using the slot in thecover plate.7. Twist the fi xture wires to the supply wires. (black to black, whiteto white, and the bare fixture wire to the supply groundwire).8. Make sure the wires do not get pinched, and swing the fixture upso the base fi ts tightly against the gasket. Push the pin throughthe hole at the top near the gasket, and into the mating loop inthe mounting bracket. You may need to tap the pin to seat it allthe way down.9. Secure the fixture with the small machine screw going throughthe cover plate and into the mounting bracket.10. Install lamp. Lamp rating must match the rating of the fixture.Model 2LBL5: 150 Watt high pressure sodium type S55 lamp.Model 2LBL6: 100 Watt metal halide type M90/O open ratedlamp.11. Hold the lens and wire cage up to the fixture and align the clipson the wire cage with the protrusions in the housing. Hook theclips over these protrusions and snap the clips closed to holdthe lens and wire cage in place.12. Loosen the screw in the center of the photocontrol socket twoturns. Twist the socket so that the arrow points north. Note: Thereis a stop to prevent the socket from turning all the way around.If you have trouble turning the socket, try turning it the otherdirection. Retighten the screw in the center of the socket.13. Align the photocontrol (it will only plug-in one way). Plug it in andtwist clockwise until it stops.14. Caulk fi xture mounting surface with silicone weather sealantTo test operation during daylight, cover the photocontrol with asmall box. Turn on the power. Not all photocontrols are alike. Somemay have a time delay of a few minutes, others will turn on as soonas power is applied. The light will take up to ten minutes to reachfull brightness. Uncover the photocontrol and your unit will operateautomatically—on at dusk, off at dawn.Lag Screw(4) MountingBracketPhotocontrolGasketCoverPlateLensPinLampHousingWARNING: Turn power off at the fuse or circuitbreaker.HEA 013Printed in China02/08Operating Instructions & Parts Manual 2LBL5, 2LBL6Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintainthe product described. Protect yourself and others by observing all safety information. Failure to comply could resultin personal injury and/or property damage! Save these instructions for future reference.®LPG-9272, LPG-9274Lamp in Fixture Contains Mercury. Dispose Accordingto Local, State, or Federal Laws. |
manualsdatabase
Your AI-powered manual search engine