MADRIX USB contact closure Quick Start Manual & Technical Manual
© 2001 – 2018 inoage GmbH | MADRIX® is a registered trademark | info@madrix.com | www.madrix.comKey FeaturesThis digital input device registers if its circuit is either open or closed.In most cases, it is used to build a switch or trigger.Incoming values are directly translated into DMX data in the MADRIX ®Software. The small unit can simply be connected to any USB 2.0 port.Example of use: Strobe or BlackoutThank you for purchasing MADRIX® USB contact closure!Please read this guide carefully and thoroughly before using MADRIX® USB contact closure.Make sure that you fully understand all information.Technical SpecificationsPower Supply DC 5 V, 500 mA, Power over USBPower Consumption ~ 25 mA during normal operationUSB USB 2.0, type A plug, Plug and Play,2 m cableDimensions (L x W x H) 44 mm x 30 mm x 23 mmWeight 57 gOperating Temp. -20 °C to 80 °CStorage Temp. -20 °C to 80 °CRelative Humidity 5 % to 95 %, non-condensing(Operating / Storage)IP Rating IP30Certificates CE, RoHSPackage Contents1x MADRIX® USB contact closure1x 3.5 mm mono jack plug1x Quick start guide / technical manualMADRIX® USB contact closure –Quick Start Guide & Technical Manual7th Edition – August 2018Please note: Check the package contents and thecondition of the interface after unpacking! Contact yoursupplier if something is missing or damaged. Do not usethe device if it seems to be damaged!Copyright Information And Disclaimer© 2018 inoage GmbH. All rights reserved.Information is subject to change at any time and without prior notice.Errors and omissions excepted. Reproduction, adaptation, or translationwithout prior written permission is prohibited. inoage GmbH does not grantguarantee on validity for a particular reason, the marketability, or otherproperties of the product. There is no way to assert a claim to inoageGmbH, neither in the legal way nor in other ways. inoage GmbH is notresponsible for damages, including all disadvantages that are not just limitedto the loss of sales, but that are caused due to the use of the product,due to the loss of serviceability of the product, due to misuse, happenings,circumstances, or actions that inoage GmbH does not have influence on,no matter if the damages as well as consequential damages are direct orindirect; whether they are special damages or others, nor if the damage iscaused by the owner of the warranty or a third person.Limited WarrantyTwo years of limited manufacturer’s warranty are grantedto the purchaser of this product. Warranty applies toconstructional fault, material defect, or incorrect assemblythe manufacturer has caused or is to be held responsiblefor. Warranty will be void if the interface is opened, modified,damaged through inappropriate handling and wrong usage,damaged through overvoltage, or damaged through anyother cause.End-Of-LifeThis electrical device and its accessories needto be disposed of properly. Do not throw thedevice into normal trash or household waste.Please recycle packaging material whenever possible. |
Related manuals for MADRIX USB contact closure
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine