FD75FlexDraper ® Combine HeaderOperator’s Manual214323 Revision BOriginal InstructionFeaturing MacDon FLEX-FLOAT Technology™The Harvesting Specialists.

MacDon FlexDraper FD75 Operator's Manual

FD75

Chapter 1: Safety

Signal Words

General Safety

Maintenance Safety

Hydraulic Safety

Safety Signs

Safety Decal Locations

Understanding Safety Signs

Chapter 2: Product Overview

Specifications

Component Identification

CA25 Combine Adapter

Chapter 3: Operation

Operational Safety

Reel Safety Props

Disengaging Reel Safety Props

Endshields

Closing Endshield

Removing Endshield

Installing Endshield

Adjusting Endshield

Linkage Covers

Installing Linkage Covers

Daily Start-Up Check

Break-in Period

Shutting down the Machine

Cab Controls

Header Setup

Optimizing Header for Straight Combining Canola

Reel Settings

Header Operating Variables

Cutting on the Ground

Header Float

Checking and Adjusting Header Float

Locking/Unlocking Header Float

Locking/Unlocking Header Wings

Operating in Rigid Mode

Checking and Adjusting Header Wing Balance

Adjusting Wing Balance

Header Angle

Controlling Header Angle

Reel Speed

Ground Speed

Adjusting Side Draper Speed

Adjusting Feed Draper Speed

Checking Knife Speed

Reel Height

Adjusting Reel Fore-Aft Position

Repositioning Fore-Aft Cylinders with Multi-Crop Rapid Reel Conversion Option

Reel Tine Pitch

Adjusting Reel Cam

Removing Crop Dividers without Latch Option from Header

Installing Crop Dividers with Latch Option onto Header

Installing Crop Dividers without Latch Option onto Header

Crop Divider Rods

Removing Crop Divider Rods

Rice Divider Rods

Auto Header Height Control (AHHC)

Sensor Output Voltage Range – Combine Requirements

Manually Checking Voltage Range

Adjusting Voltage Limits

Case IH 2300/2500 and 5088/6088/7088 Combines

Setting Sensitivity of Auto Header Height Control (Case IH 2300/2500 and

Case IH 5130/6130/7130, 7010/8010, 7120/8120/9120, and 7230/8230/9230 Combines

Setting Header Controls (Case 8010)

Calibrating Auto Header Height Control (Case Combines with Version 28.00 or Higher Software)

Setting Preset Cutting Height (Case 7010/8010, 7120/8120/9120, 7230/8230/9230)

Challenger 6 and 7 Series Combines

Engaging Auto Header Height Control (Challenger 6 Series)

Calibrating Auto Header Height Control (Challenger 6 Series)

Adjusting Header Height (Challenger 6 Series)

Setting Sensitivity of Auto Header Height Control (Challenger 6 Series)

Gleaner R62/R72 Combines

Calibrating Auto Header Height Control (Gleaner R62/R72)

Gleaner R65/R66/R75/R76 and S Series Combines (Except S9 Series)

Engaging Auto Header Height Control (Gleaner R65/R66/R75/R76 and S Series)

Calibrating Auto Header Height Control (Gleaner R65/R66/R75/R76 and S Series)

Turning Accumulator Off (Gleaner R65/R66/R75/R76 and S Series)

Adjusting Ground Pressure (Gleaner R65/R66/R75/R76 and S Series)

Adjusting Sensitivity of Auto Header Height Control (Gleaner R65/R66/R75/R76 and S Series)

Troubleshooting Alarms and Diagnostic Faults (Gleaner R65/R66/R75/R76 and S Series)