Thank you for purchasing a Macnaught K32 single handoperated grease gun.Please read and retain this instruction sheet to assist youin the operation and maintenance of this quality product.DESCRIPTIONYour Macnaught Flexigun is a pistol grip type grease guncomplete with high pressure flexible grease hose for easyaccess to those hard to reach grease points.It is designed for use with 400g cartridges or bulk grease.The filler/bleeder valve in the head also allows clean fillingfrom 20kg (35lb) grease pails using a Macnaught “J2” GreaseGun Filler Pump.The “variable stroke” feature of this grease gun allows you toachieve higher greasing pressures using short piston strokesor high volume with a full stroke.CAUTIONCaution must be observed when either unscrewing thebarrel or unscrewing the pull handle from the follower rod,the large follower spring inside the barrel is energised.A) Unscrew Barrel and “Lock” Follower (see Fig 4).C) Remove both caps from grease cartridge. Insert intoBarrel, larger open end first. Screw barrel to head tightly.B) Insert Barrel into grease and slowly pull Follower Rodout while pushing Barrel further into grease (see Fig 2)..B) Pull Follower Rod out until groove in rod can be movedinto slot in Barrel End Cap, lock the rod into end cap.K32 FLEXIGUNFig 2 Fig 31KF14502060005K32 FLEXIGUNIf Using Bulk Grease:A) Unscrew Barrel and lock Follower (see Fig 4).Select the correct follower position (see Fig 1):To select the correct follower position for bulk fill or cartridgeD) Bleed air from grease (see Fig 5).Fig 1If Using Cartridge Grease:1. Loading Gun with GreaseINSTRUCTION MANUALINTRODUCTIONIMPORTANTC) When groove in rod lines up with slot in end cap, lock rodin end cap.