Makita DC10SB Instruction Manual

Also see for DC10SB: Owner's manual Instructions

Makita DC10SB Instruction Manual Manual pdf 1 page image

SymbolsThe followings show the symbols used for the equipment. Be sure that you understand their meaning before use.• Indoor use only. • Read instruction manual.• DOUBLE INSULATION • Ready to charge.• Charging. • Charging complete.• Delay charge (Battery cooling, ortoo cold battery). • Defective battery.• Delay charge (Too hot or too coldbattery). • Cooling abnormality.• Do not short battery. • Do not destroy battery by fire.• Do not expose battery to water orrain. • Always recycle battery.Specification:Model DC10SB DC10WDInput A.C. 120 V 50 – 60 HZOutput D.C. 10.8 V – D.C. 12 V (max.)Weight 0.63 kg (1.5 lbs) 0.35 kg (0.77 lbs)• Due to our continuing program of research and development, the specifications herein are subject to change withoutnotice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003IMPORTANT SAFETY INSTRUCTIONSCAUTION:1. SAVE THESEINSTRUCTIONS– This manual contains important safety andoperating instructions for battery charger.2. Before using battery charger, read all instructionsand cautionary markings on (1) battery charger, (2)battery, and (3) product using battery.3. CAUTION – To reduce risk of injury, charge onlyMakita type rechargeable batteries. Other typesof batteries may burst causing personal injury anddamage.4. Non-rechargeable batteries cannot be charged withthis battery charger.5. Use a power source with the voltage specified on thenameplate of the charger.6. Do not charge the battery cartridge in presence offlammable liquids or gases.7. Do not expose charger to rain or snow.8. Never carry charger by cord or yank it to disconnectfrom receptacle.9. After charging or before attempting any maintenanceor cleaning, unplug the charger from the powersource. Pull by plug rather than cord wheneverdisconnecting charger.10. Make sure cord is located so that it will not bestepped on, tripped over, or otherwise subjected todamage or stress.11. Do not operate charger with damaged cord or plug. Ifthe cord or plug is damaged, ask Makita authorizedservice center to replace it in order to avoid a hazard.12. Do not operate or disassemble charger if it hasreceived a sharp blow, been dropped, or otherwisedamaged in any way; take it to a qualifiedserviceman. Incorrect use or reassembly may resultin a risk of electric shock or fire.13. The battery charger is not intended for use by youngchildren or infirm persons without supervision.14. Young children should be supervised to ensure thatthey do not play with the battery charger.15. Do not charge battery cartridge when roomtemperature is BELOW 10°C (50°F) or ABOVE 40°C(104°F). At the cold temperature, charging may notstart.16. Do not attempt to use a step-up transformer, anengine generator or DC power receptacle.17. Do not allow anything to cover or clog the chargervents.DC10SBDC10WDIMPORTANT: Read Before Using.