NAPCO GEM-RECV-XPS Installation Instructions Manual
    |
®NAP CDNAPCO SECURITY SYSTEMS. INC.333 BAYVIEW AVENUEAMITYVIU.E, NE:W YOAK 11701SALES, REPAIRS &TECHNICAL SERIIICECAll. 10U. FREE: (800) II4H4-45TECHNICAL 8eRvtcc DIRECT UNECAU. 10U. FREE; (800) II4IHM40DESCRIPTIONGEM-RECV-XP8 receiver Is the hardwired interface toNapco's Wireless-Ready,. XP-Serles and GEM-P800 Con-trol Panels. The wireless system comprises an XP-400: -XP-600 or GEM-P800 panel, at least one GEM-RECV-XP8receiver and one or more companion transmitters. Thetransmitters may be wireless smoke detectors, space-protection devices, window/door sensors, or other devicesthat report zone status and supervision information to thereceiver without the use of wires.THE GEM-RECV-XPB RECEIVERThe GEM-RECV-XPB wUI accommodate up to 8 wirelesstransmitters, 4 GEM-SMK wireless smoke detectors, and 4GEM-KEYF Key-Fob transmitters. The receiver is con-nected to the keypad 3-wlre bus. The receiver monitorseach transmitter, updating transmltter status as reports arereceived, and conveys this information to the control panel.Also monitored is the elapsed time since the last report fromeach transmitter. If no report Is received within aprogrammed time, the panel wDI issue a Supervisory Failuresystem trouble.COMPATIBLE TRANSMITTERSAny of the following Napea wireless transmitters may beused with the GEM-RECV-XP8 receiver.• GEM-TRANS2 Window/Door Sensor. This super-vised, two-point transmitter provides an Internal mag-netic reed switch and/or terminals for one or twoexternal normally-closed devices.• GEM-TRANS4 Window/Door Sensor. As above, but 4points.• GEM-PIR. Dual-element passive infrared sensor. -• GEM-DT. Dual-technology PIA/microwave sensor.• GEM-SMKSmoke Detector. Supervised smoke detec-tor.• GEM-KEYF Key Fob Transmitter. Keychaln/pendantremote arming or emergency transmitter.• GEM-GB. Glass-break sensor.SPECIFICATIONS, GEM-RECV-XP8 ReceiverOperating Temperature: ooc to 49"CStorage Temperature: -20°C to + 85°CPower Requirements: 12Vdc, SOmA (supplied by panel)'Mreleu Ready .. Ia a trademark of Napco Security Systems, Inc.IINSTALLATION INSTRUCTIONS IGEM-RECV-XPSWireless Receiver forXP-Series and GEM-PSOOControl PanelsWI848A 10/96Antenna: t/4-wave (4)Dimenslo.ns: 6" x 3511" x 1112" (HxWxD, less mounting tabs)ORDERING INFORMATIONNote: Batteries are induded with all transmitters.GEM-RECV-XP8 8-Polnt Receiver/Interlace with fourGEM-DTGEM-GBGEM-KEYFGEM-PIRGEM-SMKGEM-TRANS2GEM-TRANS4DL123AantennasDual-technology PIRJMicrowave sensorGlass-Break DetectorHand-Held Key Fob Pendant/KeychainPanic ButtonPassive Infrared TransmitterSupervised Smoke Detector2-Point Window/Door Transmitter4-Polnt Window/Door TransmitterReplacement Lithium Battery for GEM-TRANS2, GEM-PIR (2) and GEM-GB (2) (bulk packed)INSTALLATIONDesigning the SystemIn planning the layout of the system, give careful con-sideration to the location of the receiver. Regardless ofwhere the control panel Is mounted, the receiver should becentrally located Within the premises, that Is, approximatelyequally distant from all transmitters. Choose a location ashigh above ground level as practical (attic Installations arenot recommended), keeping In mind that metal objects mayadversely affect reception Draw a layout of the system,Identifying all proposed transmitter locations and anticipatedreceiver location Also Include notations Indicating construc-tion materials In use. Although wood and wallboard con-struction wUI have little effect upon signal strength at thereceiver, concrete or brick can reduce signal strength byup to 35%, while steel-reinforced concrete or metal lath andplaster can reduce transmitter strength as much as 90%.In installations where distant transmitters pose receptionproblems, two receivers (maximum) may be used. Thepanel will respond to receiver with the stronger signal. Bothreceivers are connected to the panel's 3-wlre bus, but theymust be addressed differently so that they can be Identifiedby the control panel. This Is accomplished by the placementof jumper JP1 at the lower-left comer of the board. Refer to |
Related manuals for NAPCO GEM-RECV-XPS
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine