NAPCO SLE-WIFI-MODULE Installation Instructions Manual
  | |
Contents | 
Standoff with its hole,and the two HeaderPlugs with their Head-er Sockets (Fig. 4).Insert: Firmly press theSLE-WIFI-MODULE intothe radio PC board.ANTENNA MOUNTING For radios with a plastic housing, follow steps 5A and 5B. For radios with a metal housing, follow steps 5C and 5D.5A. Plastic Housings: Remove the Break-Away Tab fromthe Antenna Mounting Bracket with pliers (Fig. 5A).5B. Plastic Housings: The other end of the Antenna WirePlug is an " Antenna Socket" (Fig. 5B).Slide this Antenna Socket into the space formerly occu-pied by the Break-Away Tab. Position a washer aboveand a washer below the Antenna Mounting Bracket asshown.333 Bayview Avenue Amityville, New York 11701For Sales and Repairs, (800) 645-9445For Technical Service, (800) 645-9440 or visit us athttp://tech.napcosecurity.com/(Note: Technical Service is for security professionals only)Publicly traded on NASDAQ Symbol: NSSC© NAPCO 2017 WI2191LF 3/17WIRELESS CONNECTIVITYSLE-WIFI-MODULEINSTALLATION INSTRUCTIONSThe SLE-WIFI-MODULE allows your Napco StarLink ™ de-vice to connect to the Internet by means of a wireless (Wi-Fi)link, eliminating a wired Ethernet cable connection. For moreinformation about the StarLink SLE Commercial and Residen-tial Dual-Path Alarm Communicators, see WI2189 andWI2190.Note: The SLE-WIFI-MODULE requires 40mA, thereforethe existing battery inside the housing may need to be re-placed with a larger battery; verify sufficient power is availableif the radio is powered by the FACPPrior to opening the SLE-WIFI-MODULE PCboard package or touching anything inside the ra-dio enclosure, discharge any static electricity fromyour body or clothing. Use a grounded wrist strapor touch an unpainted, grounded metal object.Install as follows:1. Insert the plastic Standoff into the bottom of theSLE-WIFI-MODULE (Fig. 1).2. Insert the very small Antenna Wire Plug into its socketon the SLE-WIFI-MODULE PC board and press until theplug snaps in place and freely rotates but remains connect-ed (Fig. 2). Important: Handle this wire with care; do nottwist, create sharp bends or apply excessive force.3. Power off the radio by disconnecting the positive +VDC+PWR wire from terminal TB1.4. Align: Use Fig. 3 to find the Header Sockets near the topof the radio PCB. With radio power off, carefully align theFig. 2: Antenna Wire PlugFig. 4: Align and InsertFig. 1: Standoff (arrow)Fig. 5A: Break-Away Tab (arrow)Fig. 3: "Header Sockets" (circled) |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine