NAPCO SLe-GSM Installation Instructions Manual
                | |
StarLink ™ SLe-GSM and SLe-GSM-3/4G Series GSM Communicators Installation Instructions 1INTRODUCTIONThe StarLink ™ SLe-GSM and SLe-GSM-3/4G alarm cap-ture communicators are fully supervised, wireless digitaltwo-way subscriber units supported by an extensive na-tionwide wireless network:• SLe-GSM - 2G Network Compatible• SLe-GSM-3/4G - 2G, 3G and 4G Network CompatibleBoth models are compatible with virtually any alarm con-trol panel and are easy to install and test. Either modelcan function as a backup to existing telephone lines, or asa primary communicator when telephone lines are absentand when connected directly to the control panel Telcoterminals. When used as a backup communicator, bothGSM units will automatically switch the communicationchannel from the telephone line to the network when tele-phone line trouble is detected. Enclosure tamper protec-tion is also provided for both models.Note: In this manual, "SLe-GSM" refers to both modelsunless otherwise stated.The SLe-GSM and SLe-GSM-3/4G use proprietary data-capture technology that captures the alarm report from thecontrol panel and transmits the alarm signals to the SLeControl Center; the alarm signals are then forwarded toANY Central Station via standard CS receiver formats 4/2and Contact ID. In addition, the SLe Control Center gen-erates and reports a Supervisory signal in the event thatthe network does not receive the expected supervisorytest signal from the wireless communicator during a pre-scheduled period.The GSM alarm signals are transmitted on the RF data-only portion of the GSM digital network, providing a fast,dependable communication path to the central station.GSM RADIO REPORTING PATHThe above diagram shows the transmission path of a sig-nal from the GSM to the central station.1. Signal from a Control Panel.2. SLe-GSM (or SLe-GSM-3/4G) receives the signaltransmission (from the TIP an RING wires); sends RFsignal through the GPRS network operator.3. Network Operator, part of the vendor system, a sec-tion of the cellular spectrum.4. SLe Control Center, receives and routes data.5. Central Station.ORDERING INFORMATIONSLE-GSM - 2G Network Compatible GSM alarm captureCommunicator, SIM card included.SLE-GSM-3/4G - 2G, 3G and 4G Network CompatibleGSM alarm capture Communicator, SIM card included.SLE-SMTCHG - Optional, Smart Charge Module. Re-quired for installations where the control panel cannot pro-vide the 65mA of Auxiliary power required to operate theSLe-GSM radio. Allows use of standard 4AH / 12V re-chargeable battery to provide radio standby power. Seeinstallation instructions WI1946.SLE-DLEXT - Optional, for up/downloading, extends dis-tance from radio to panel, from 10 feet, up to 100 feet.See installation instructions WI1950.SLE-DLCBL - Download Cable, 6 feet.SLE-ATT/4 - Kit of four (4) AT&T™ network compatibleSIM (Subscriber Identity Module) cards for installations inareas without or with insufficient T-Mobile™ coverage.SLE-ANTEXT - Extended antenna with 15 feet of cable.SPECIFICATIONSElectrical Ratings for +12VInput Voltage: 15-10.6VDCInput Current: 65mA with peak RF transmission current of400mAElectrical Ratings for the IN 1 Burg/Fire Input:Input Voltage: 15-9VDCElectrical Ratings for IN 2 and IN 3:Maximum Loop Voltage: 15VDCMaximum Loop Current: 1.2mAEnd of Line Resistor (EOLR) Value: 10KElectrical Ratings for 3 PGM Outputs:Open Collector Outputs: Maximum Voltage 3V when ac-tive; 15V maximum when not activeMaximum PGM Sink Current: 50mAPhysicalDimensions without Antenna (WxDxH): 4.8" x 7" x1.2" (12 x 17.8 x 3 cm)StarLink ™ SLe-GSM and SLe-GSM-3/4GSeries GSM CommunicatorsINSTALLATION INSTRUCTIONSWI1936B 02/13R333 Bayview AvenueAmityville, New York 11701For Sales and Repairs, (800) 645-9445For Technical Service, (800) 645-9440Publicly traded on NASDAQ Symbol: NSSC © NAPCO 2013( ( ( ( ( ( ( ( ( ( ) ) ) ) ) ) ) ) ) )(1)(2)ControlPanelNetworkOperatorSLe Control Center(3)CENTRALSTATION(5) (4)) ) ) ) ) ) )RF DATASL e -GSMSL e-GSM-3/4G |
Related manuals for NAPCO SLe-GSM
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine