IBR-TOUCH & IBR-TOUCH-WL Quick Start Guide 1© NAPCO 2018 WI2297LF preliminary draft # .25 4/18NAPCO iBridge ™ IBR-TOUCH &IBR-TOUCH-WL Touchscreen Tablets1 Unpack the touchscreen tablet (look carefully for the sup-plied mounting hardware; the Power Adapter is only included withthe model IBR-TOUCH-WL)Note: If using older ISEE Series Cameras, use your existingISEE-WAP (with its power adapter and CAT5 cable, shown).IBR-TOUCH-WL TouchscreenRear Case2 Mount the touchscreen rear case to the wall usingscrews appropriate for the mounting surface.Power must be provided with the IBR-TOUCH-WLusing the 12VDC power adapter, observing polarity(use the wire hole located in the center of the rearcase, shown below). The IBR-TOUCH connectsto the Gemini security system 4-wire bus.3 Apply power to the control panel, the touchscreenand the ISEE-WAP / IBR-ZREMOTE / StarLinkConnect radio. Upon power up, both touchscreenswill start within about 5 seconds (both can be manu-ally powered by pressing and holding the small but-ton on the right side for 10 seconds).4 Upon power up, the Setup Wizard will automaticallystart. Follow the sequence of images as shown in thefollowing steps, as necessary for the in-stallation type. If the Setup Wizard doesnot automatically start, press and holdthe System Settings ("gear") icon, enteryour Dealer password, then tap SetupWizard."center hole" forpower or keypad buswiresCAT5 CableISEE-WAP Power AdapterPower AdapterTap Yes and set the date, time and Time Zone (ifnecessary). IMPORTANT: Outdated digital certifi-cates will disallow connection to your iBridge orStarLink Connect system, as well as inhibiting nec-essary automatic firmware downloads.5 Wait for the system diagnostics process to complete.Functional components are marked with a check;items not configured or not enabled are marked witha "x". Selections are blank when the Setup Wizard isrun for the first time. Tap Configure to continue.6..System SettingsbuttonQUICK START GUIDE