NC-link NC-AP211 How To Configure
Also see for NC-AP212: User manualUser manual
   |
www.nc-link.cn1How to configure 3-Step Quick Connection of NC-LINKOutdoor CPE in WDS modeFor NC-AP211 & NC-AP2121. Interface Instruction:LAN: 10/100Mbps RJ45 port, can support 24V Passive PoE.WAN: 10/100Mbps RJ45 port, can support 24V Passive PoE, but it changes to LAN port underWDS, Repeater and AP operation modeReset: Reset Button, press 10~15 seconds, outdoor CPE will revert to default settings.DC: 12V/1A DC input injector.F(fn): Mean Function, can select the CPE’s channel and master or slave mode.S: Mean Selection, can select the functions or view CPE’s Channel, IP address and Signal strengthstatus.LED Display: Show the status of Channel, IP Address, Master or Client, RF Power.LED Display Content Content Instruction RemarkH: Hotspot, WDS mode, Master AP149: Channel is 149Show the channel of Master and Slave AP;Pls note, the channel should be same withMaster and Slave AP.If not operate this LED display in 10 mins,the screen will be automatically blackscreenC: Client, WDS Mode, Slave AP149: Channel is 149A: IP Address253: IP address is 192.168.188.253Show Master and Slave AP’s IP address;Remark:In Master and Slave APs, there is onedevice with IP address: 192.168.188.253;Other device with IP of 192.168.188.X, toavoid the IP address conflict.,P: RF Power-42: The signal Strength is -42dBmThe signal strength is different if distancedifferent. |
manualsdatabase
Your AI-powered manual search engine