![NCR P1535 Quick Reference Manual Manual pdf 1 page image](https://manuals-archive2.s3.amazonaws.com/3932181/abee367ee2f6d40b36e20107b8685b1e1f.jpg)
497-0478005 Rev AP1535/P1235 Quick ReferenceGuideGraphical OverviewAccessories IncludedPower Connection10ft (3m) Network Cable6ft (2m) Power Cable 90°The P1535/P1235 has an integrated 19 V, 90 W power supply ratedfor 110 V and 240 V (auto-sensing), 50 Hz or 60 Hz located in thebase.If the power supply is not installed in the base of the P1535/P1235:a) remove upper stand cover b) loosen thumbscrew that secures thebase cover c) route AC power cord thru base d) install power brick inbase e) secure cables behind CableLock Cover and close all.a) b)c) d)e)Power Button and I/O Panel Access1 – Removable SSD2 – Power Button3 – Recovery Button4 – RJ12 Cash Drawer5 – HDMI6 – Display Port7 – Power In8 – RJ45 Serial Ports (2)9 – Ethernet Port10 – USB 3.011 – RJ12 Serial Ports (2)12 – 12V Powered USB13– RJ12 Serial Port14 – USB 3.0 (3)Expansion Options:A– 24V Powered USB +RJ12 Serial Ports (2)B – 5V USB + RJ12 SerialPorts (2)C – RJ45 Serial Port + SIM+ POENCR Recovery Utility P-Series stand removalThe NCR Recovery utility can be used to restorethe factory provided image, or make backups. Thedefault password is “Recovery1234”.To start the recovery process, tilt head back toexpose the I/O panel. The unit must be poweredoff before beginning the process.Press and hold the recovery button. Whileholding the recovery button, press the powerbuttom to power on the unit. Wait 5 seconds,and release both buttons.Recovery Button*Press once and releaseLay terminal face down on a flat surface.Remove the screws (2) that secure the Base Stand tothe display.Rotate the P-Series Stand and remove the MountingPlate Tabs (2) from the openings in the Rear Cover.Note: 24V Power Supply is external to baseX-Series Stand Wall MountP-Series Stand