USE AND CARE GUIDEPATH LIGHTMODEL # NEB-LSP-0015A Light Body (1) B Connector Clip (1) C Ground Stake (1)1. Preparation• Before beginning assembly of product, make sure all partsare present. Compare parts with package contents list. Ifany part is missing or damaged, do not attempt to assemblethe product.• Estimated installation time: 10-15 minutes.• No Tools Required for Assembly.2. Assembly• Screw together the light body (A) and the ground stake (C)as shown above. Ensure the wire goes through the centerof the stake.3. Installation• Determine the location of your light. Dig a small starter holein the ground with a screw driver or trowel.• Press the stake into the hole until the light is secure, butcan still be adjusted.• Dig a small trench from the light to the transformer wire.• Secure the connector clip (B) to the transformer wire, asshown above.• Test the connection by turning on the lights. Make anydesired adjustments.• Secure the light in the ground and fill in the trencheswith dirt.ASSEMBLY AND INSTALLATIONWARNING: Never use a hammer to insert the light into the ground.WARNING: The wire connector (B) contacts have sharp edges for piercing themain low voltage cable. To avoid injury, do not touch the metal contacts.CAUTION: The wire from low voltage power unit should be 12-18 AWG typeunderground Low Energy Circuit Cable.IMPORTANT:• Do not submerge the fixture in water.• Do not install the fixture within10 ft. of water.• The landscape wire can also behidden under surface.• Protect the wiring by routing it inclose proximity to the light fixture,or next to a building structure.ACB(Power Pack Sold Separately)