These instructions are customized for theCNet Modem V.90 56k bps modem (P/N85862D) contained in the 28i Modem Kit P/N92766, 124i Modem Kit P/N 92066B, and the384i and 704i Modem Kit P/N 92366. The modem connected to the system DCI or LAPB(called the site modem) should be modem P/N85862D. The modem connected to your PC (calledthe office modem) should be P/N 85862D or anequivalent modem. This modem supports V.42 ErrorCorrection. If your office modem accepts commandAT&Q5, it is V.32/V.42 compatible. You must use your system’s Remote Maintenanceprogram - system programs are not interchangeable.(Example: You cannot use the 124i RemoteMaintenance program with 384i system.)i-SeriesRemote ModemInstallation InstructionsPart No. 92600MDM11November 2001Printed in U.S.A. (2106)

default settings

NEC 28i Installation Instructions Manual

124i Enhanced

VoIP PCB Overview

Hardware Considerations

Configuration for IP Address Determination

Dial Edit

Incoming Calls

VoIP PCB Setup Examples

Conditions

Programming

Firmware Upgrade

Comprehensive Hotel/Motel Features

message waiting

do not disturb

Do Not Disturb

DSS Console Monitoring

Message Waiting

PMS Integration

Alarm Displays

Wake Up Call

Room to Room Call Restriction

Setting Up PMS Integration

Room Status Printouts

Single Digit Dialing

Toll Restriction (When Checked In)

programming procedures

before programming

how to enter the programming mode

dss console operating mode

hotel room status printer

class of service

dss console extension assignment

pms restriction level conversion table

flexible system numbering

system numbering

trunk access code