Quick Connect Guide MultiSync LT150/LT85Step1 Connect the supplied 15pin-15pin signal cable.Connect the supplied power cable.Step2Step3 Turn on the projector.NOTE: To turn off the projector, press and hold the POWER button for aminimum of two seconds.Power cable (supplied)Step4 Set up the ProjectorFocus ringTo adjust the projector's focus use the Focus ring on the lens.1. Lift the front edge of the projector.2. Press the Tilt button on the top of the projector to extend the Adjustable TiltFoot.3. Press and hold the Tilt button.4. Lower the front edge of the projector to the desired height and release the Tiltbutton to lock the Adjustable Tilt Foot.• If the projected image does not appear square to the screen then use keystone correction forproper adjustment. See page 31 or 37 of the supplied user's manual.AC INPC CARDUSBVIDEOS-VIDEORGBAUDIOPC CONTROLPC CARD ACCESSSTATUSPOWERON/STAND BYSOURCEAlways power down before you make any connections.AC INPC CARDUSBVIDEOS-VIDEORGBAUDIOPC CONTROLMENUENTERCANCELSELECTAUTOADJUSTPC CARD ACCESSSTATUSPOWERON/STAND BYSOURCEVIDEOS-VIDEORGBAUDIOPC CONTROLRGB INPUT1ONDIP2 3 4 5 6Mini D-Sub 15 pinconnectorRGB cable (supplied)For older Macintosh comput-ers which do not have a miniD-Sub 15 pin connector, usea commercially available pinadapter to connect to yourMacintosh’s video port.AUDIOMEAUTAPC CARSTATUSPOWERON/STAND BYSOURCEAdjusting the Tilt FootMENUENTERCANCELSELECTAUTOADJUSTPC CARD ACCESSSTATUSPOWERON/STAND BY SOURCE443MENUENTERCANCELSELECTAUTOADJUSTPC CARD ACCESSSTATUSPOWERON/STAND BY SOURCE112To fine-adjust the height of the rear foot,remove the spacer and rotate the rear footto the appropriate height.Spacer