NEC SV-8100 User Manual

Also see for Univerge SV8100: User guide User guide User guide User guide Quick reference guide

NEC SV-8100 User Manual Manual pdf 1 page image

NEC SV-8100Multiline Telephone User GuideDigital or IP PhonesNEC SV-8100 - User Introduction for Display PhoneHOLD. The red HOLD button at the bottom of the phone is used to put calls on hold.TRANSFER. The TRANSFER button is used to transfer calls to another phone. Totransfer a call, press the TRANSFER button, then dial the extension number of thephone you want to send the call to. When the person answers, you can eitherannounce the call or just hang up. If the voice mail answers by mistake, dial *** andthe voice mail will disconnect.SPEAKER. The SPEAKER button activates the speakerphone.ANSWER. The ANSWER button is used to answer a second call, like call waitingCONFERENCE. The Softkey under CONF button is used to set up a conference call byadding on callers. Press CONF, then dial 9 and another number. After the personanswers, press CONF or the Softkey BEGIN to add them in. Repeat this until allparties are on the line. As an option, we have a dedicated conference card that willadjust levels for up to 16 callers.RECALL. The RECALL button is used to transfer calls if you have Centrex or Centranetlines only. Otherwise this button can be used to disconnect a call and give you freshdial tone.FEATURE. The FEATURE button is used for programming.MIC. The MIC button turns on/off the built in microphone. Most prefer to leave themicrophone on (light on) so you can use the speakerphone and talk back intercom.Either UP and DOWN arrows or a Joystick are located at the bottom right of thephone. Use these buttons to change ring volume, speaker volume, handset volume,and contrast on the LCD screen, depending on what your phone is doing at the time.