Reference2x3 screws for thestand assemblyNEC PLASMA TABLE TOP STANDStep 3.Carefully place theNEC Plasma on aflat soft surfaceStep 4.Remove the screwswith the cross pointscrewdriverStep 5.Slide the supportbrackets into thebaseStep 6.Secure the standwith the six screwsStep 7.With assistance,carry the entire unitto the desiredlocation and divertthe protective foilfrom the standStep 1.Open packagingStep 2.Put stand on a tableCONTENTS:- NEC Table Top StandREQUIRED TOOLS:- Six crosshead screws (Please unscrew from NEC Plasma, see “reference”)- Cross point screwdriverINSTRUCTIONS2951-4042-C001 Rev.00

NEC T1000 - STAND MOUNTING Instructions Manual

Safety instructions

Waste disposal

Overview

Connection sockets

Remote control

Local operator control

Getting started

Installation

Connecting and switching on the display

SDTV - HDTV compatible

Switching on the display

OSD Menu

Picture

Contrast

Size

NR (Noise Reduction)

TV channel

Manual Store

Manual Store - Colour System

Manual Store - Channel

Manual Store - Search

Add / Delete

Sort

Fine Tune

TV Sound

Balance

Auto Volume

Setup

Time - On Timer

Time - Off Timer

Time - On Timer Volume

OSD Tone

PIP (Picture In Picture)

PIP - Size

PIP - Sound Select

Custom

H-Position

Troubleshooting

Technical specfication

Appendix

Connecting pin assignment for VGA

T1000 - STAND MOUNTING