NEMA Reliance Controls Easy/Tran TF151 Manual
Congratulations on your purchase of the Reliance Controls Easy/Tran TF furnace transfer switch. Reliance hasbeen manufacturing transfer switches and equipment in Racine, Wisconsin since 1982 and has been producinghigh-quality electrical equipment for nearly 100 years. Reliance is the Loadside® transfer switch used in nearly90% of the installations done by professional electricians. Your transfer switch is UL 1008 listed, for the U.S. andCanada, and meets all requirements of the National Electrical Code.STANDBY POWER FURNACE SWITCHEasy/Tran® TF151, TF151W, TF201 and TF201WTOOLS NEEDED FOR INSTALLATION1. Power Drill 6. Tape Measure2. Wire Stripper and Cutter (10 to 14 gauge) 7. Three Wall Anchors3. Insulated Screwdrivers 8. Battery Powered Lighting during Installation(#2 Phillips, ¼” Flat Tip or #2 Square Tip 9. A Non-Contact Voltage Detector (optional)depending on your load center)4. Hammer5. Marking PencilPARTS LIST for Easy / Tran TF FURNACE TRANSFER SWITCH15 Amp (TF151) or 20 Amp (TF201) Single-Circuit Transfer Switch4 Yellow Wire ConnectorsSAFETY SYMBOLS USED IN THIS MANUALDanger indicates an imminently hazardoussituation that, if not avoided, could result indeath or serious injury.Warning indicates a potentially hazardoussituation that, if not avoided, could result indeath or serious injury.Caution indicates a potentially hazardoussituation that, if not avoided, may result inminor or moderate injury.Improper installation of the transferswitch could cause damage or personal injury byelectrocution or fire. Installation must be performedby a qualified electrician, or others knowledgeable ofelectrical systems, in compliance with all applicableelectrical codes.Reliance transfer switches covered inthis manual should not be used for electric waterheaters, clothes dryers, electric ranges, central airconditioners or other appliances or systems that mayexceed the capacity of the product.Transfer switches are required for use with portablegenerators by Article 702 of the National Electrical CodeReliance Controls Corporation isnot responsible for damage orinjury caused by incorrectinstallation of this transfer switch.Member of the National Electrical Manufacturers Association |
manualsdatabase
Your AI-powered manual search engine