NONLINEAR LABS C15 Manual
Also see for C15: User manualQuick startUser manualTutorialQuick start
               |
1C15 - Pedal Manual1. Features of the Pedal Inputs• Support for almost all types of expression pedals and damper pedals of differenttechnology and connector pin-outs. Further, many model-specific pedal presets can beselected for optimized performance.• Support for “Control Voltage” as additional type of controller.• Auto-Ranging to fully use the available electrical travel of a pedal.• Auto-Hold to de-noise and stabilize the controller output.• Controller parameters (like current Auto-Ranging internal settings) are continuouslysaved, and re-loaded after power-up.2. Quick Start1. If the pedal has a detachable cable, then first connect a suitable cable to the pedal. Ifthe pedal has a “minimum volume” setting adjust (like many Roland and Boss modelsdo), set it to the fully counter-clockwise position.2. Connect the pedal cable to the C15 at one of the TRS Sockets numbered “Pedal 1...4”.The C15 may already be powered on or off, it does not matter. If on, try to insert thecable quickly into the TRS socket (in less than 1 second).3. Go to “Setup > Device Settings > Pedals” and select the proper type for the pedal fromthe pedal presets list. If your pedal is listed explicitly then please use that setting.Otherwise, try the generic “Pot, Tip-Active” (also known as Boss/Roland pin-out) or“Pot, Ring-Active” (Yamaha pin-out) presets.4. Do the Auto-Ranging cycle: Move the pedal to one end stop of its mechanical travel,wait a moment (1 second), then move it to the other end stop, wait a moment.5. Check if the position indicator in the Pedal Editor screen moves evenly and over thewhole range of 0%...100% when operating the pedal over the complete travel. Whenusing one of the generic “Pot” settings and you find that the approximate “center”position gives a way too high (or too low) reading, try the corresponding generic pedalpresets with the swapped pin-out (swap “tip active” with “ring active”).6. During operation, when you find that the pedal does not move over the complete0%...100% range anymore, reset the Auto-Ranging by temporarily selecting anotherpedal type. Alternatively, you can pull the cable from the TRS socket and re-plug it. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine