NTech Skywatch Eole Meteos Owner's Instructions Manual
You have just acquired a piece of high precisionequipment which has been created using the mostmodern technology. It has been designed to standup to intensive use. However, in order to maintain itsappearance and its precision, we recommend thatyou treat it with care and read this manual carefully.Function of the buttonsON : press for 1 secondOFF : press for 2 seconds (not auto off)LIGHT : press on and off brieflyUP : setting modeSTART / STOP : chronometer modeDOWN : setting modeLAP / RESET : chronometer modeSET / CAL : setting modeRESET MEMORY : press for 3 secondsConfigurationTo access the configuration mode of your instrument,just press on the button. Pressing the button onceagain cause the system to confirm the setting if therehas been a change. If not then it goes to the nextsetting. To modify the settings the and buttonshave to be used. Here is how to proceed with thedifferent instrument settings.Wind measuring unit ( + )The units to be selected are : knots, km/h, m/s, fps andbft. Once the unit is chosen, it remains displayed inthe top right. If no other unit is chosen the instrumentis set to the Beaufort.Temperature measurement unit ( )The units to be selected are : °F, °C, °F and °C .Setting the time of the average ( + )The times to be selected are : --- (weighting), 3’’, 6’’,12’’, 30’’, 1’, 6’, 30’, 1:00’, 6:00’, 12:00’, 24:00’ or timer .The timer mode allows measurement of the averagebetween start (press ) and stop (press ), this timeis displayed on the lower lines. This timer allows theuse of the LapTime function (press , the symbolflashes). The button also allows the timer to be resetto zero. This works in the same way as a standardchronometer.Setting of the wind and temperature displays ( )The displays to be selected are : ---, MIN, AV, MAX.If AV is selected, the average of temperature and windare shown. The display of average values is alwaysmade simultaneously for the wind (at the centre) andtemperature (at the bottom). The other modes (---,MIN, MAX) only concern the temperature.Setting of the display is not possible if the unitsselected are °F or °C .Measuring the windImportant : the protective cap has to be removedfrom the instrument in order to rotate the impeller.The impeller has a maximum sensitivity in thevertical position (due to its magnetic levitation), andan optimised precision when its axis of rotation isperpendicular to the wind direction.InMThthofduAvThavThMInImafgrtimisWAspoBupatetehatecatetecythchMThvaThofofTe› S› Tt› Ai› A› T› T› PBot› W› D› WWYomELThinThmsutrashth+Owner’s InstructionsMode d’emploiBedienungsanleitungManual de instruccionesLibretto d’instruzioni |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine