JN-UG-3096 v1.1 © NXP Laboratories UK 2013JN5168-RD6040IoT Gateway Kit Getting StartedIntroductionThe NXP ‘Internet of Things’ (IoT) Gateway enables the control of wireless nodes ina WPAN from IP-connected devices in a LAN or WAN (e.g. smart phones, tabletsand laptops). It is used with a conventional IP router (which acts as a DHCP server)to provide an interface between the LAN/WAN and WPAN domains. The gateway isdesigned around the NXP LPC3240 microcontroller and NXP JN5168 wirelessmicrocontroller. The LPC3240 device provides a Linux-capable processing platformfor the LAN/WAN interface. The JN5168 device provides the processing platform forthe WPAN interface as well as 2.4GHz radio communication with the WPAN.Kit ContentsCheck the contents of the kit, which are listed below.• IoT Gateway unit *• Universal 12V DC power supply unit **• Swivel SMA antenna• 1-metre RJ45 Ethernet cableBefore using the IoT Gateway, make sure you attach the supplied antenna to theSMA connector on the unit.* RF information: IEEE 802.15.4 Tx/Rx, frequency range 2400–2483.5 MHz, 2 dBmOperating temperature: 0ºC to 40ºC (32ºF to 104ºF)Operating humidity: 10% to 85% relative humidity (non-condensing)** Mass Power SFF1200100U1BA or Stontronic T5148RWUsing the IoT GatewayThe IoT Gateway is supplied pre-programmed with the JenNet-IP Border-Routersoftware, which is described in the Border-Router Application Note (JN-AN-1110)available from the NXP Wireless Connectivity TechZone (web address over-page).This allows the gateway to be used with the JenNet-IP Smart Home Demonstrationthat is pre-programmed into the components of the NXP JN516x-EK001 EvaluationKit. This kit and demonstration are fully described in the JN516x-EK001 EvaluationKit User Guide (JN-UG-3093), also available from the TechZone.