Single Rope SwingCongratulations on your purchase. You now have one of NagsHead Hammocks’ innovative products! If you have any ques-tions regarding this product, we invite you to call us 7 days aweek at 800-344-6433.Helpful tips before starting: • Get someone to help you. Somepieces are heavy and a second pair of hands always helps. •Do not tighten the bolts completely until the product is fullyassembled. Some pieces are harder to fit in place and this willhelp. A hammer or rubber mallet is needed during assembly.• Do not over-tighten the bolts or screws. • Build your itemclose to where it will be used to eliminate difficulty in movingonce completed. • For a uniform look, face all nuts in the samedirection.Step 1. Set Rollup on flat surface such as a work table. Align holes of LeftArm with holes located on the side of the Rollup. FIGURE 1Hardware 8 - 3.5” x ¼ Hex Bolt2 - 4” x ¼” Barrel Bolt2 - 4.5” x ¼” Barrel Bolt4 - ¾” Barrel Bolt Fasteners8 - ¼” Locknuts16 - ¼” Washer1 - Allen Wrench2 - Chain Assemblies2 - Tree HooksStep 2. Starting with back hole of Arm, thread 3.5” Bolt through Washer,through Arm and Rollup. Secure with Washer and Locknut. Repeatprocess for holes at front of Arm. Note: This step may require a Mallet totap Bolts through. FIGURE 2Step 3. Repeat Step 2 for Right Arm.FIGURE 1FIGURE 2Parts: Swing Roll-upLeft ArmRight ArmLeft UprightRight UprightCupHolderFront of rollupSpacer BarSUGGESTED TOOLS(NOT PROVIDED)• Rubber Mallet• Standard Phillips Head Screwdriver• Adjustable Wrench