Naish Fusion ATB Control System 2016 Manual
  |
1. Measure the distance from the bar tothe line organizer. This should be 82 cm.3. Take your box cutter and cut off theknot inside the handle.4. Tape the end of the trim line so thatit doesn’t fray and allows you to feed itthrough various spare parts later.5. Take handle and yellow ball off theend of the line. Then pull the line out ofthe line organizer and cleat so that it isnow entirely free.Tip: The bradawl tool comes in handyhere when pulling the line out throughthe cleat.2. Measure the distance from the bar tothe cleat. This is typically 54 cm.7. Pull the trim line completely out of thequick release mechanism.8. The end of the trim line is looped ontothe cleat. Use the bradawl to loosen andremove the trim line from the cleat entirely.9.Take the taped end of the trim lineand insert between the roller and thebridge starting from the cleat side ofthe metal body. Important: Do not insertit under the roller as it was when youdisassembled it.6. Pull the quick release open so youhave access to the trim line underneath.10. Guide it through the loop at the endof the trim line and pull it tight.11. Feed the taped end of the trim line upthrough the bottom of the yellow handle.1.How to Adjust the Trim Line on the2016 Fusion ATB Control System |
Related manuals for Naish Fusion ATB Control System 2016
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine