Napoleon BIZC450 Instruction Manual
ZERO CLEARANCE INSULATING LINERINSTRUCTION GUIDEThis liner is designed for use in a combustible enclosure; the liner must be supported from the bottom by a ledge on either side or a full deckbeneath the liner (refer to opening diagram). Please use this manual in conjunction with your main manual to properly assemble your builtin grill.KIT CONTENTSBOTTOM PANEL 1PCSIDE PANELS 2PCSREAR PANEL 1PC#8 x ½” TEK SCREWS 15PCS#14 x ½” HEX HEAD SCREWS 6PCSThe installation must be performed by a licensed gas fitter, and all connections must be leaktested before operating the grill.N415-0152 NOV21/06BUILT IN PROPANE GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should belocated as shown in the built-in instructions. Do not use hose to connect the unit. It must be connected with either rigid pipe,copper tube or an approved flexible metal connector. The installation must comply with CAN B149.1 Natural Gas and Propaneinstallation code in Canada, or to the National Fuel Gas code, ANSI Z223.1 in the United States. The minimum recommendedpiping size is NPS 1/2" for rigid pipe, and 1/2" OD for copper tubing (based on a 20 ft run). Longer runs may require larger sizesto conform with CAN B149.1. Propane Gas Installation Code in Canada or to the National Fuel Gas Code, ANSI Z223.1 in theUnited States. The gas supply must be connected to the 3/8” flare elbow fitting located under the right hand side of the controlpanel. If installing a side burner, a separate line must be branched off to the side burner unit and enter the side burner openingat the specified location. If the enclosure is to house a propane cylinder, the tank portion of the enclosure must be ventilatedaccording to local codes, and must not have communication with the cavity used to enclose the gas grill. The tank can not bestored below the gas grill.BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should belocated as shown in the built-in instructions. Do not use hose to connect the unit. It must be connected with either rigid pipe,copper tube or an approved flexible metal connector. The installation must comply with CAN B149.1 Natural Gas and PropaneInstallation Code in Canada, or to the National Fuel Gas Code, ANSI Z223.1 in the United States. The minimum recommendedpiping size is NPS 1/2" for rigid pipe, and 5/8" OD for copper tubing (based on a 20 ft run). Longer runs may require larger sizesto conform with CAN B149.1. Natural Gas Installation Code in Canada or to the National Fuel Gas Code, ANSI Z223.1 in theUnited States.Built in units are supplied with a drip pan which holds only a minimal amount of grease. To prevent grease fires, the panmust be cleaned after each use.HGASINLETOPENING6.500”WD2”MIN34” RECOMMENDEDBIZC450 35.875” 22.937” 11.125”BIZC600 44.125” 22.937” 11.125”Model DimensionsW D H2.000” |
Related manuals for Napoleon BIZC450
manualsdatabase
Your AI-powered manual search engine