PARTS LISTINSTALLATION AND OWNER’S MANUALLight Bar N925 for Installation to:Kawasaki ® VN1500D&E and VN800B Pages 1,2,3 and 5Kawasaki ® VN1600 Pages 1, 4 and 5QTY. PART NO. DESCRIPTION1 N925 Light Bar AssemblyBag 1546 80-850000-000 Scotchlok Connectors2 49-490521-000 Washer Flat (for VN1600 only)2 50-571100-000 Screw, M6 x 16 (for VN1600 only)Tools needed to remove fuel tank.Screw Driver, #2 PhillipsSocket 10mm and Ratchet WrenchSocket 27mm, 3” Extension and WrenchHex Key Wrench, 5mmSlip Joint PliersFloor Jack capable of lifting front of motorcycle.Motorcycle Owner’s ManualScrew Driver, #2 PhillipsScrew Driver, Flat Blade8mm WrenchSlip Joint PliersMotorcycle Owner’s ManualPage 1 of 5 10-110725-000 06/03PREPARATION VN1500D and VN800B PREPARATION VN1600Make certain the motorcycle is positioned securely onits sidestand or a work stand.Cover the front fenderto avoid scratches due to a dropped part or tool.Make certain the motorcycle is positioned securelyon its sidestand or a work stand.Cover the frontfender to avoid scratches due to a dropped part ortool.2. Remove the head lamp from the Headlight Shell(Screwdriver), set aside.3. Disconnect Turnsignal Wires Inside headlight Shell.4. Remove Turnsignals: (Refer to the motorcycle owner’smanual)REPLACEMENT PARTS and ACCESSORIESOrder parts through your local dealer or contact National Cycle.N925Description Part No.Light Head Assembly 90-910501-000Lamp Assembly E13/DOTReflector, Lens and Bulb 90-901011-000Halogen H3 Bulb 90-901015-000Turn SignalAssembly 90-930921-000Turn Signal Lens 90-930213-000Turn Signal Bulb Only: Bulb 1157 Available at Most Auto Parts Stores.Light Bar AccessoriesChrome Visor N9005Alternate Thumb Switch N9001TOOL LIST VN1600 InstallationTOOL LIST VN1500D&E and VN800B InstallationTips for facilitation of operation, controland adjustment, as well as maintenancework.Special notes and cautionary measureswhich can prevent damage to the motor-cycle.Left and Right side of motorcycle is determinedwhile sitting on the bike.