CALIBRATION PROCEDUREFD-11613/116148-Channel/16-Channel Temperature Input Device for FieldDAQThis document contains information for calibrating the FD-11613 and FD-11614. For moreinformation about calibration, visit ni.com/calibration.ContentsSoftware Requirements............................................................................................................. 1Documentation.......................................................................................................................... 2Test Equipment..........................................................................................................................2Test Conditions..........................................................................................................................2Calibration Procedure............................................................................................................... 3Initial Setup....................................................................................................................... 3Verification........................................................................................................................4Adjustment........................................................................................................................ 7EEPROM Update.............................................................................................................. 8Reverification....................................................................................................................9Accuracy Under Calibration Conditions...................................................................................9Where to Go for Support.........................................................................................................10Software RequirementsCalibrating the FD-11613 or FD-11614 requires the installation of NI-DAQmx on thecalibration system. NI recommends using the latest NI-DAQmx driver. Earliest driver supportversion for calibrating the FD-11613 or FD-11614 is listed in the following table.Table 1. FD-11613/11614 Driver SupportDriver Earliest Version Support for Device CalibrationNI-DAQmx 18.1You can download NI-DAQmx from ni.com/downloads. NI-DAQmx supports manyprogramming languages, including LabVIEW, LabWindows™/CVI™, C/C++, C#, and VisualBasic .NET. When you install NI-DAQmx, you only need to install support for the applicationsoftware that you intend to use.