National Instruments FieldPoint cFP-20 Series Quick Start Manual

Also see for FieldPoint cFP-20 Series: User manual Quick start guide

National Instruments FieldPoint cFP-20 Series Quick Start Manual Manual pdf 1 page image

FieldPoint TM1cFP-20xx Quick Start Guide©National Instruments CorporationcFP-20xx Quick Start GuideWhat You Needto Get Set Up• cFP-20xx LabVIEW RT controller• Mounting hardware (DIN rail,panel-mount, or rack-mountaccessory)• I/O module(s)• cFP-BP-x backplane, connectorblocks, cables• 11–30 VDC power supply• Accessories: Ethernet cable,number 2 Phillips screwdriver• PC running Windows• FieldPoint software 3.0.2 or later• LabVIEW RTMount the Compact FieldPoint BackplaneYou can mount the cFP-BP-x backplane on a 35 mm DIN rail, on a panel, or in astandard 19 in. rack. Before using any of these mounting methods, record the serialnumber from the back of the backplane.Each set of mounting instructions in this document includes an instruction to connectthe protective earth (PE) ground terminal on the cFP-BP-x backplane to the systemsafety ground. The backplane PE ground terminal has the following symbol stampedbeside it: . Connect the backplane PE ground terminal to the system safety groundusing 14 AWG (1.6 mm) wire with a ring lug. Use the 5/16 in. panhead screw shippedwith the backplane to secure the ring lug to the backplane PE ground terminal.1