National Instruments NI PXI-4110 Getting Started Manual

Also see for PXI-4110: CALIBRATION PROCEDURE Getting started guide

National Instruments NI PXI-4110 Getting Started Manual Manual pdf 1 page image

GETTING STARTED GUIDENI PXI-4110Triple-Output Programmable DC Power SupplyNote Before you begin, install and configure your chassis and controller.This document explains how to install, configure, and test the NI PXI-4110 (NI 4110). TheNI 4110 is a triple-output programmable DC power supply.To access NI 4110 documentation, navigate to Start»All Programs»National Instruments»NI-DCPower»Documentation.ContentsElectromagnetic Compatibility Guidelines............................................................................... 1Verifying the System Requirements..........................................................................................2Safety........................................................................................................................................ 2Unpacking the Kit..................................................................................................................... 2Kit Contents.............................................................................................................................. 3Other Equipment............................................................................................................... 4Preparing the Environment....................................................................................................... 4Installing the Software.............................................................................................................. 4Installing the NI 4110................................................................................................................5Configuring the NI 4110 in MAX.............................................................................................7Programming the NI 4110.........................................................................................................8Troubleshooting........................................................................................................................ 8What Should I Do if the NI 4110 Doesn't Appear in MAX?............................................ 8What Should I Do if the Module Fails the Self-Test?.......................................................9Where To Go Next.................................................................................................................. 10Worldwide Support and Services............................................................................................ 10Electromagnetic Compatibility GuidelinesThis product was tested and complies with the regulatory requirements and limits forelectromagnetic compatibility (EMC) stated in the product specifications. These requirementsand limits provide reasonable protection against harmful interference when the product isoperated in the intended operational electromagnetic environment.This product is intended for use in industrial locations. However, harmful interference mayoccur in some installations, when the product is connected to a peripheral device or test object,or if the product is used in residential or commercial areas. To minimize interference with