Getting Started with the NI PCIe-1433The NI PCIe-1433 (NI 1433) is a PCI Express (PCIe) image acquisition device that supports Base,Medium, Full, and Extended Full configuration Camera Link-compatible cameras. The NI 1433supports Power over Camera Link (PoCL). This document describes how to install and configurethe necessary hardware and software components to begin using the NI 1433.What You Need to Get StartedYou need the following items to set up and use the NI 1433:❑ NI 1433 image acquisition device❑ Camera Link-compatible camera❑ One 26-pin MDR Camera Link cable for Base configuration cameras❑ Two 26-pin MDR Camera Link cables of the same length for Medium, Full, or Extended Fullconfiguration cameras❑ Computer running Microsoft Windows 7 (32-bit and 64-bit versions)/Vista (32-bit and 64-bitversions)/XP/2000 with at least one available x4 or larger PCIe slot❑ NI-IMAQ 4.4 or later driver software, which is included with NI Vision Acquisition Software❑ Optional software for developing machine vision applications:• NI Vision Builder for Automated Inspection• NI Vision Development Module, which requires one of the following application developmentenvironments:– LabVIEW– LabWindows ™ /CVI™– Microsoft Visual StudioOptional EquipmentNational Instruments offers a variety of products for use with the NI 1433, includingthe following:• NI Camera Link I/O Extension Board (PCIe) for additional triggering, timing and I/O(Part number 780869-01)• SMB to BNC cable, used for front panel trigger I/O (part number 763389-01)Visit ni.com, or call the National Instruments office nearest you for specific information about theseproducts.