National Instruments PXIe-5622 Getting Started Manual

Also see for PXIe-5622: Getting started guide CALIBRATION PROCEDURE Getting started guide

National Instruments PXIe-5622 Getting Started Manual Manual pdf 1 page image

GETTING STARTED GUIDENI PXIe-562216-bit 150 MS/s DigitizerThis document explains how to install, configure, and test the NI PXIe-5622 (NI 5622). TheNI 5622 is a 150 MS/s digitizer with onboard signal processing (OSP). The NI-SCOPEinstrument driver ships with the NI 5622 and programs the device.Note Before you begin, install and configure your chassis and controller.To access NI 5622 documentation, navigate to Start»All Programs»National Instruments»NI-SCOPE»Documentation.ContentsElectromagnetic Compatibility Guidelines............................................................................... 1Verifying the System Requirements..........................................................................................2Unpacking the Kit..................................................................................................................... 2Kit Contents...................................................................................................................... 3Other Equipment....................................................................................................................... 3Preparing the Environment....................................................................................................... 3Installing the Software.............................................................................................................. 4Installing the NI 5622............................................................................................................... 4Hardware Front Panel Connectors.................................................................................... 6Configuring the Hardware in MAX.......................................................................................... 7Programming the NI 5622.........................................................................................................8Troubleshooting........................................................................................................................ 9Why Is the ACCESS LED Off When the Chassis is On?.................................................9What Should I Do if the NI 5622 Doesn't Appear in MAX?............................................9What Should I Do if the Module Fails the Self-Test?.....................................................10Thermal Shutdown Error................................................................................................ 10Where To Go Next.................................................................................................................. 11Worldwide Support and Services............................................................................................ 11Electromagnetic Compatibility GuidelinesThis product was tested and complies with the regulatory requirements and limits forelectromagnetic compatibility (EMC) stated in the product specifications. These requirementsand limits provide reasonable protection against harmful interference when the product isoperated in the intended operational electromagnetic environment.