National Instruments Quanser QNET MI Quick Start Manual
       |
Quick Start GuideQNET Mechatronic Interfacing for LabVIEW™Step 1: Check Components and DetailsFigure 1: QNET Mechatronics Interfacing BoardThe Quanser QNET Mechatronic Interfacing consists of a single PCB module (shown in Figure ??)Note: The QNET curriculum resources are available fordownload at www.ni.com/ni-elvis/courseware or www.quansershare.com/qnetsStep 2: Additional Components Required for Setup(a) ELVIS II(b) Power Supply (c) USB CableFigure 2: ELVIS II(+) ComponentsTo complete your QNET Mechatronic Interfacing setup, you willalso need the following hardware:1. NI ELVIS II or ELVIS II+ workstation2. +5VDC / 5A, +15VDC / 2A, -15VDC / 0.8A Power Supply3. USB CableQNET MI Quick Start Guide v 1.0 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine