National Instruments SCB-100 Installation Manual

Also see for IMAQ SCB-100: Installation guide Installation guide Installation guide

National Instruments SCB-100 Installation Manual Manual pdf 1 page image

INSTALLATION GUIDE AND SPECIFICATIONSNI SCB-100Shielded 100-Pin Connector Block for Plug-In DAQ DevicesThis guide describes how to connect and use the NI SCB-100 with 100-pin data acquisition(DAQ) devices.The SCB-100 is a shielded desktop accessory with 100 screw terminals, a cold-junctioncompensation temperature sensor for use with thermocouples, and a strain-relief bar forsecuring signal wires or cables.The SCB-100 connects to E Series MIO devices (NI 6025E, NI 6031E, NI 6033E, and NI6071E), DIO devices (PCI-DIO-96, NI 6508, NI 6509, NI 6511, NI 6512, NI 6513, NI 6514,NI 6515, NI 6527, and NI 6528), TIO Series devices (NI 6624), or other products with a 100-pin 0.050 series shielded D-type I/O connector.Note To use the SCB-100 with a DIO or TIO Series device, you must change thedefault switch setting. Refer to the Using the SCB-100 with DIO/TIO Devicessection for more information.The following illustration shows the SCB-100 components.