National Instruments SCXI-1348 Installation Manual

National Instruments SCXI-1348 Installation Manual Manual pdf 1 page image

NATIONALINSTRUMENTS @The Sofrware k the Instrument @SCXI-1348 DIO-32FCable AssemblyInstallation GuidePart Number 320620-01This guide describes how to install the SCXI-1348 cable assembly between an SCXI module and Ian AT-DIO-32F, MC-DIO-32F, or NB-DIO-32F data acquisition board. In addition to theSCXI-1348 kit contents, you will also need an SCXI chassis, an SCXI module, a computer, aDIO-32F data acquisition board, and a small flathead screwdriver.IntroductionWith the SCXI-1348 cable assembly, you can connect a digital I/O SCXI module to yourDIO-32F data acquisition board. The DIO-32F works with the SCXI-1160, SCXI-1161,SCXI- 1162, and SCXI- 1163 modules.If you have a newly released module or a data acquisition board other than a DIO-32F, contactNational Instruments for information on your cable needs.The SCXI-1348 cable assembly consists of an adapter board and an NB4 50-conductor shieldedribbon cable that connects the adapter board to a DIO-32F data acquisition board. The adapterboard converts the signals from the DIO-32F I/O connector to the pinout that a digital SCXImodule rear signal connector uses. To extend the unconverted signals of the DIO-32F to anothermodule or to an SCXI-1180 feedthrough panel, you can use the male breakout connector that ison the center of the adapter board.What Your Kit Should ContainThe contents of the SCXI-1348 cable assembly kit are as follows:I Kit Name andPart NumberComponentIComponentPart Number ISCXI- 1348 CableAssembly (776574-48) Cable adapterTwo small screws1 m NB4 shielded 50-pin ribbon cable.SCXI-1348 DIO-32F Cable AssemblyInstallation Guide182252-01742413-01180554-10320620-01If your kit is missing any of the components, contact National Instruments.0 1993 National Instruments Corporation. All rights reserved. June 1993

/ 4

Related manuals for National Instruments 776574-48