National Instruments TB-2676 Installation Instructions Manual

National Instruments TB-2676 Installation Instructions Manual Manual pdf 1 page image

INSTALLATION INSTRUCTIONSNI TB-2676IntroductionThis guide describes how to install and connect signals to theNational Instruments TB-2676 terminal block. Use the ribbon cableheaders of the NI TB-2676 to access all channels of the NI PXI-2576multiplexer for all configurations.Refer to the NI Switches Getting Started Guide to determine when to installthe NI TB-2676.To set up and use the NI TB-2676 terminal block, make sure you have thefollowing items:❑ NI TB-2676 terminal block❑ NI PXI-2576 switch module❑ 1/8 in. flathead screwdriver❑ #1 Phillips screwdriver❑ Eight 0.100 in. pitch 2 × 10 ribbon cable assemblies, or wire wrapcable and toolsConnecting SignalsCaution Ensure that power has not been applied to signals prior to connection. Onlytrained and qualified service personnel should install and connect signals.To connect signals to the terminal block, refer to Figure 1 and complete thefollowing steps:1. Remove the terminal block top cover screw.2. Gently lift the top cover off the terminal block.̭͈Ρ΅νιϋΠ͉ͅȂ඾ུࢊβȜΐ͜܄̞̳ͦ̀͘͘ȃ

/ 4

Related manuals for National Instruments TB-2676