Navitar 642MCL1028 Installation Instructions Manual

Installation of Navitar NuView Series 642 lens on Dukane model ImagePro 8711projector.TOOLS REQUIRED: PHILLIPS HEAD SCREWDRIVERDisassembly:1. Disconnect unit from power source and place projector with lens facing you. Removetwo (2) screws (one on each end) holding front cover of projector. Remove screwfrom bottom-center of projector. Remove cover and set aside for reinstallation.2. Remove four Phillips head screws holding prime lens in place and disconnect thepower cable for the zoom/focus motor and remove prime lens.Assembly:1. Ensure that your Navitar lens and its adapter are separate. Using four (4) Phillipshead screws removed in (2), above, install the adapter correct side up into theprojector.2. Replace the front cover of the projector removed in step 1, above.3. To focus, gently twist the front of lens. To zoom, loosen thumbscrew and twistknurled ring (zoom lenses only, of course). Re-tighten thumbscrew. CAUTION: Donot twist entire lens out of adapter!

/ 1

Related manuals for Navitar 642MCL1028