Page 1Single Door Access Module NESS-M1KAMFEATURES:z Input for a 26 bit Wiegand Readerz Heavy Duty Form "C" Relay Contacts for Switching Door Strike Powerz Low Current (50mA) 12VDC Output for Door Held Open Alarmz Low Current (50mA) 12VDC Output for System Ready To Arm indicationz Low Current (50mA) 12VDC Output for System Armed indicationz Supervised Input for RTE (Request To Exit) Button/Devicez Supervised Input for Door Status Sensorz Installs in place of an M1 Keypad and operates from the RS-485 4-Wire KeypadData Busz Four selectable Time settings for "Request to Exit" and "Door Held Open"z Hardware Watchdog CircuitSPECIFICATIONS:z Connections: Unpluggable Screw Terminals, 16 Positionz Operating Voltage: 13.8 VDCz Current Draw: Less than 30 mA with min. activity, 44 mA fully activez Housing Dimensions: 4.25" x 6.375" x 2.125"z Circuit Board Dimensions: 3.95" W x 2.875" H x .95" DFeatures and Specifications subject to change without notice.Doc No. 890-373 - 10 May 2007APPLICATIONA single door access interface module for use on the M1 and M1EZ8Control Panels. The M1KAM connects to the 4 wire keypad data bus inplace of a traditional M1 Keypad. Since the maximum number ofkeypads on an M1 or M1EZ8 is 16, the maximum number of M1KAMmodules (and controlled doors) is 16, minus any installed keypads.Even though an M1 Keypad can accept a 26 bit access reader, theM1KAM is a more powerful and less expensive access solution. Forexample; the M1KAM includes a relay (door unlock) output with form "C"dry contacts, making it compatible with most door lock devices regard-less of the voltage rating and style (AC or DC). The M1KAM acceptsmany types of card swipe or proximity readers conforming to the 26 bitwiegand format.The M1KAM also has additional inputs and outputs, including: arequest to exit (RTE) button or device and a Door Contact (Sensor)input. Both inputs are supervised with a 2,200 EOL resistor. Outputson the M1KAM consists of a voltage output for Door Held Open Alarm,a voltage output for System Ready to Arm, and a voltage output forSystem Armed. These outputs are 12VDC (switched negative) and arerated for a maximum current of 50 milliamps. The M1KAM is mountedin a universal surface mount plastic housing with knockouts for surfacemount raceways.Ness Security Products - 4/167 Prospect Hwy, Seven Hills. NSW, 2147http://www.ness.com.au • email: sales@ness.com.au