Net to Net Uplink Interface Module UIM-10/100 Installation Instructions Manual
     | |
220-0000016 rev01UIM-10/100Uplink Interface ModuleINSTALLATION1. Unpack and inspect the equipment.The following components should be included:If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-877-638-2638 (001-603-427-0600 for international customers) or support@nettonet.com.2. Install the UIM-10/100.Required tool for installation: Phillips screwdriver.UIM Installation in an IP DSLAMAffix the UIM to a Multiplexer Uplink Module (MUM).a. Place the MUM on a flat surface with the circuit board facing up.b. Select a port on the MUM for UIM installation; either port (1 or 2) may be used.Although not required for operational purposes, if redundancy is desired, two UIMsmay be installed on the MUM, one in each port.Installation InstructionsCAUTION Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions whenhandling this equipment.! 1 UIM-10/100! 4 #6 Phillips Panhead Internal Locking Screws! 2 #6 Phillips Beige Flathead ScrewsNOTE The UIM may be attached to a MUM that has already been in service, although you must remove theMUM from the IP DSLAM in order to do so. Removal of a MUM from an IP DSLAM chassis that ispowered up will not affect the operational status of other modules within the chassis; itwill, however, disengage the IP DSLAM's upstream network connection. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine