NeuraLabel 500e Quick Start Manual

NeuraLabel 500e Quick Start Manual Manual pdf 1 page image

NeuraLabel 500e Accessories – Roll to Roll Setup4800 Sugar Grove Blvd., Suite 200 ~ Stafford, Texas 77477 ~ 1-800-364-8728 ~ 1-281-240-2525 ~ www.neuralog.comAttach disk without theguide to the spindlewith two screws.Screws are pre-installedin each spindle.Repeat with otherspindle.Slide the Rewind Unitwith Base under theprinter. Align printerto blue tape. Thistakes 2 people.The back feet on thebottom of the printerwill align into twoholes in the baseplate.Rewind UnitL-Base Platewith 4 screwsPower Supply& AdapterSpindles withbuilt-in Chucks (2)Lower Disks(2)Upper Diskswith Guide(2)Attach the spindles,lower one first.Align set screw toflat surface onmotor shaft.Use the Allen Key tolock the set screw inplace.Tools:Allen Key (provided)Phillips screwdriver(not supplied)Smooth side of thedisk faces in and willtouch the media.Do the same forthe upper spindle.Make sure bothspindles aresecurely fastenedto the Rewind UnitAttach L-Base Plate toRewind Unit with 4Phillips screws (provided)and set upright. bluetape

/ 2

Related manuals for NeuraLabel 500e