NightStick XPR-5592 Instruction Manual
Also see for XPR-5592: Instruction manual
    |
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.comINS-XPR-5592-FE-19 05-10-2019Instruction ManualXPR-5592THE XPR-5592 IS APPROVED FOR USECLASS I DIV 1 GRPS A-D T4CLASS II & III DIV1 GRPS E-G T135°CCLASS I ZONE 0 GROUP IIC T4 Ga-20°C ≤ Tamb ≤ +40°C3.7V/Cell Li-ionBayco Products, Inc. XPR-5592FLOODLIGHT FOR USE IN HAZARDOUS LOCATIONSFor use with Bayco Li-ion Battery Pack 5592-BATT only640 S. Sanden Blvd., Wylie, TX 750980359INTRINSICALLY SAFESECURITE INTRINSEQUEE 467756ELECTRICAL SAFETYID 4002026WARNINGS - INTRINSICALLY SAFE• WARNING: Use only the approved Nightstick 5592-BATT Lithium-ion rechargeable battery pack or theapproved non-rechargeable batteries listed below.• WARNING: To prevent ignition of a hazardous atmosphere, do not open the battery compartmentor attempt to exchange any of the supplied battery packs while in the hazardous environment. Thistask must ONLY be performed in an area known to be non-hazardous.WARNING: To prevent ignition of a hazardous atmosphere, the approved Nightstick 5592-BATTLithium-ion rechargeable battery pack must only be charged in an area known to be non-hazardous.• WARNING: To reduce the risk of explosion, do not mix new non-rechargeable batteries with usednon-rechargeable batteries, or mix non-rechargeable batteries from different manufacturers.• WARNING: Substitution of components may impair intrinsic safety.SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETYFor personal safety, always confirm the rating of any known hazardous or potentially hazardouslocation where the Angle Light is to be used.CAUTION• Rechargeable Lithium-ion batteries must be used and charged properly. Improper use can resultin serious injury, fire, or death.• Do not leave the battery in direct sunlight or use or store the battery inside cars in hot weather.• Do not expose the battery to water or salt water, or allow the battery to get wet.• Do not store the battery with metallic objects that may cause a short circuit.• Immediately discontinue use of the battery if the battery emits an unusual smell, feels hot, changescolor, changes shape or appears abnormal in any way.• Keep out of the reach of children.INITIAL USEWarning: To prevent ignition of a hazardous atmosphere, do not attempt to charge thisproduct in the hazardous environment. This task must ONLY be performed in an area knownto be non-hazardous.Fully charge the XPR-5592 before the fi rst use, or if the battery is new or has been unused for severalmonths. The maximum charge time required is approximately 6-7 hours.DAILY USEWARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT ATTEMPT TOCHARGE THIS PRODUCT IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST ONLY BEPERFORMED IN AN AREA KNOWN TO BE NON-HAZARDOUS.• Use only the supplied Nightstick AC, DC adapter, or USB cord. For best performance, charge theXPR-5592 when the light starts to dim.• Connect the AC, DC adapter, or USB cord into the bottom of the light.• The total time to full charge the XPR-5592 varies depending on the remaining charge in thebattery pack.• For the light to be waterproof, the charging port must be well covered by the screw cap. (Image 1)OPERATIONCAUTION: BECAUSE THE XPR-5592 HAS A MAGNETIC BASE, IT IS LIKELY THAT IT WILL BEPLACED IN AN ELEVATED POSITION ABOVE THE GROUND. THEREFORE CAUTION SHOULDBE USED TO BE CERTAIN THAT THE MAGNET IS SECURELY ATTACHED TO THE METALSURFACE BEFORE RELEASING THE LIGHT. IT IS ALSO ADVISED THAT EXTRA CARE BETAKEN WHEN ADJUSTING OR MOVING THE CORD SO THAT THE WORK LIGHT DOES NOTCOME LOOSE AND FALL TO THE GROUND.The XPR-5592 has a single three-position toggle switch with black boot. Operation as seen fromthe back of the light:• Center position: Off• Right position: High-brightness• Left position: Low-brightnessImage 2Image 1 Image 3SETTING UP THE WORK LIGHT ON A TRIPODOpening the tripod leg set:Fully unfold the tripod leg set and slide the center collar down until it locks into place.WARNING: Do NOT attempt to use the tripod leg set unless the legs are fully extended andlocked into place. This is the ONLY position that the leg set can be used in.Closing the tripod leg set:Press the release button on the side of the center collar and then raise the center collar up untilthe tripod leg set is fully retracted.Adjusting the column sections:The tripod has two adjustable sections of the column that can be used to customize the workingheight of the work light. Each section is locked into place by means of a cam lock lever. (Image 2) Toadjust the height of either section, release the cam lock lever for that section, extend the column to thedesired length and the re-lock the cam lock lever.Removing the light from the tripod:The product is designed so that the light can be removed from the tripod. To remove the light, graspthe lights handle with one hand, and grasp the top of the tripod stand with the other hand a pull themagnet apart from the mounting plate.Installing the light onto the tripod:CAUTION: Before installing the light on to the tripod, be certain that the leg set is fully extendedand locked in place and that both of the two column cam lock levers are securely locked.To install the light head on to the tripod, simply line up the light heads magnetic base with thetripods mounting plate (Image 3) allowing the magnet to secure itself to mounting plate. Be sure placethe light head directly onto the center of the mounting plate so that the light head is securely mounted.WARRANTY1 YEAR WARRANTYBayco Products, Inc. warrants this product to be free from defects in workmanship and materials to theoriginal purchaser for 1 year from the date of purchase, and includes the LEDs, housing, lenses, electronics,switches, rechargeable batteries and chargers. Bulbs (other than LEDs) are covered for 90 days from thedate of purchase.We will repair or replace this product should we determine it to be defective. This is the only warranty,expressed or implied, including any warranty of merchantability or fi tness for a particular purpose.For a complete copy of the warranty, go to www.nightstick.com/nightstick-product-support/warranties.Retain your receipt for proof of purchase. |
Related manuals for NightStick XPR-5592
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine