Nikon N50 Quick Start Manual

Nikon N50 Quick Start Manual Manual pdf 1 page image

WHILE YOU'RE TAKING PICTURESUsing the Built-In FlashO ^ O The flash can be usedwhen the subject is within0.6 to 3m (2.0 to 9.8 feet)when using a film withISO 100 and the AFZoom-Nikkor 35-80mmf/4-f/5.6 D lens.If 4 blinks inside the viewfinder, use the built-in flash. Press the flashlock release button. Lightly press the shutter release button, wait for the4 to come on in the viewfinder. Confirm the • (in-focus indicator)appears in the viewfinder, then fully depress the shutter release button.• If 4 blinks after shooting for a few seconds, this means that the lightmight be insufficient. Check shooting distance, and if necessary,move closer to subject and take a picture with flash again.If a stationarysubject starts tomoveRemove your finger fromthe shutter releasebutton and lightly pressagain to restartautofocus.Viewfinder informationW H I hi I blinks—OverexposurepossibleUse a film with lower ISO, oruse a Nikon Neutral DensityFilter.Lo blinks—UnderexposurepossibleUse the built-in flash.4 blinks (without flash)—-1,_" Flash recommendationThis happens when it's dark.Use the built-in flash.[ ] blinks inside viewfinder—Picture blur is possibleThe light is probably dim and theautomatically selected shutter speed isslow. This can cause picture blur dueto camera shake. Hold the camerasteady, or use a tripod. Or, use a built-in flash.• blinks—Unacceptable conditionfor autofocusAutofocus requires that the subjecthave some contrast or details to focusupon. Make sure the subject conforms.You can't focus on the sky, a blankwall, a very shiny surface, a subjectwhich has no details or contrast.WHEN YOU'VE TAKEN A COMPLETE ROLLAuto RewindWhen the film reaches the end of roll, it rewinds auto¬matically. After rewinding is completed, remove the film.•When battery power is very weak, or when temperature isvery low, film may not rewind at the end of roll; Err will appearin the LCD panel. In this case, replace battery with a freshone, or wait for the temperature to rise and then press therewind button.To rewind film at mid-roll: Press therewind button on the camera bottom.Shortcut to Great PicturesNikon N50 SHOOTING IN SIMPLE MODERead this Instruction Sheet to learn operate your N50, please also read thehow to use your N50 camera in the N50 Instruction Manual booklet, afterSIMPLE mode. you have become familiar with theFor additional information about how to SIMPLE mode.IMake sure the power switch is turned Q Insert 6-volt lithium battery pack (2CR5off. Attach the AF Nikkor lens. Z or Duracell DL245 type).3 Turn on the power switch and load film. mark and close the camera back. Film auto-Pull the film leader out to the red index matically advances to frame #1.

/ 2

Related manuals for Nikon N50