Nikon OneShot360 CoolPix950 Instructions Manual

Nikon OneShot360 CoolPix950 Instructions Manual Manual pdf 1 page image

md www.remotereality.comTelephone: 508-870-1500Facsimile: 508-870-8777Nikon CoolPix950 Instructions forOneShot360™Recommended Camera Settings• Turn the camera on to the manual recording mode (M-REC)• Set image quality to Fine. This is accomplished by holding down the "QUAL" buttonlocated below the color LCD screen and rotating the dial located in front of and below theshutter release button until "FINE" appears in the lower right hand corner of the color LCDscreen.• Disable the flash. To toggle between the different flash modes, including OFF, press theflash mode button located to the right of the small digital LCD screen near the shutterrelease button. The flash mode is indicated on both LCD screens (on the right hand sideof the small digital LCD screen and in the upper right hand corner of the larger color LCDscreen).• We recommend zooming in until the circular OneShot360 image exactly fills the digitalcamera LCD viewer screen. If you zoom in too much, you will lose part of the field of view.If you zoom in too little, you will not get maximum resolution. Note also that theOneShot360 image may not be exactly centered in the LCD screen – this is normal. Thezoom control is located on the same side of the camera as the color LCD screen in theupper right hand corner. You must re-calibrate the zoom level after powering the cameradown.• For indoor shots, put the camera in aperture priority mode. This is done by holding downthe "MODE" button located below the color LCD screen and rotating the dial in front of andslightly below the shutter release button. You are in aperture priority mode when the letter"A" appears in the lower left hand corner of both LCD screens. Next set the camera to themiddle of 3 aperture settings (approximately F4.7 at the correct zoom level forOneShot360 images). You can see the aperture value in the lower middle portion of thecolor LCD screen and also in the smaller digital LCD screen. For outdoor shots, automaticexposure is fine. This mode is indicated by the letter "P" in the lower left hand corner ofboth LCD screens.• The Nikon CoolPix 950 is equipped with a timer. This allows the photographer to exit thearea before the shot is taken. This button is located on the same side of the camera asthe smaller digital LCD screen, on the lower right hand side. Press the button 3 times untilthe timer symbol appears in the upper left hand corner of the color LCD screen. The timermust be manually re-enabled for each shot that you want to use it.• Now make sure the camera is set to a focal distance of 1.5 meters. The button for placingthe camera in manual focus mode is the same as that for setting the timer, so if you wantto use both the timer and a manual focus setting, you must enable the timer first.Otherwise the camera will be set back to auto focus mode when you enable the timer. Toinput a manual focus distance, press and hold down the manual focus mode button asyou rotate the dial located just in front of and below the shutter release button. Rotate thatdial until 1.5 appears on either LCD screen.

/ 2

Related manuals for Nikon OneShot360 CoolPix950