Nilfisk-Advance SC800 User Manual

Also see for SC800: Service manual Instructions for use How-to User and maintenance guide Troubleshooting guide

Nilfisk-Advance SC800 User Manual Manual pdf 1 page image

Nilfisk A/SKornmarksvej 1DK-2605 BrøndbyDenmarkTel.: +45 43 23 40 50Fax: +45 43 43 77 00mail.com@nilfisk.comwww.nilfisk.comIf the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this thisprocedure may cause damage to the batteries. Charging the batteries after every use is recommended.PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASISUse and Maintenance- SC800ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual2. Fill the tank with a clean water. Theclean water temperature must notexceed 40 °C.1b. Disconnect the battery chargercable from the electrical main.3. Fill the EcoFlex tank with a deter-gent suitable for the work to beperformed (highly concentrateddetergent).4. Install the squeegee and fasten itwith the handwheels, then connectthe vacuum hose to the squeegee.1a. Switch off charger by pressing theSTOP button. Unplug charger cablefrom red battery plug. Reconnectthe red battery plug to the machine.17. Clean the machine using a dampcloth and where needed use a neutralcleaning product.15. Press the switch and wait for thebrushes to fall on the floor.Removethe brushes and clean them.16. Take the squeegee off and removedebris. Check and clean the squeegeeblades.18. Charge the batteries: Connect thebattery charger cable from the elec-trical main.19. Park the machine with the recoverytank cover open.12. At the end of the work. Empty therecovery tank with the hose. Thenempty the solution tank with thetrasparent hose10. Lower the squeegee with the lever. 11. Push the drive paddle for startingfloor cleaning. If solution appliedflows outside the brush housing dur-ing use, reduce the flow of solution.Switch off the machine using the key.13. Wash with clean water the recoverytank and the vacuum grid. Removeand clean the debris tray.14. Clean the filter: 1) Close the solu-tion tap under the machine. 2)Remove the transparent cover andthe gasket, then remove the filterstrainer.7. Press the solution flow controlswitches as necessary, dependingon the type of cleaning to be per-formed.5. Place the brushes or the pad-holdersunder the deck. Use the appropriatebrushes to clean the floor.6. Turn the ignition key to “I”, thenlower the deck by pressing the Greenswitch. To engage the brushes,slightly press the drive paddle andthen release it.8. Press the detergent flow controlswitch. The number of display showsthe detergent concentration level in thesolution (see the table on the label).See the User Manual for setting change.9. Press the EcoFlex™ switch wheneveryou temporarily need a greater clean-ing power.External battery charger Machine with battery charger

/ 2

Related manuals for Nilfisk-Advance SC800