Nite Ize INOVA STS Product And Warranty Information
    |
Lampe Frontale LED • Informations sur le Produit et la GarantieLinterna Frontal con luz de diodo LED • Información del producto y garantíaLampada da Testa LED • Informazioni sul Prodotto e sulla GaranziaLED - Stirnlampe • Produkt- und Garantie-InformationenLED Hoofdlamp • Informatie over het Product en de GarantieНалобного Фонаря LED • Продукт и гарантийные обязательстваLED Pannlampa • Produkt och GarantiinformationLED Headlamp • Product and Warranty InformationSTS ™HEADLAMPBefore first use, INSTALL BRACKET with elastic headstrap:• Align flatter part of bracket with bottom edge of headlamp (lettering onstrap should be right side up).• Orient posts in bracket to small holes on either side of the headlamp.• Snap bracket posts into holes in headlamp.INOVA® STS™ Headlamp OPERATION GUIDE:To TURN ON White or Red LED:• From the Off mode, swipe left (in the direction of thewhite arrow on swipe pad) for White LED.• From the Off mode, swipe right (in the direction of thered arrow) for Red LED.To toggle through MODES (High, Medium, Flash, Off):• Swipe once to enter High mode (left for White LED orright for Red LED).• Swipe 2 times to enter Medium mode. Swipes mustbe repeated within 2 seconds.• Swipe 3 times to enter Flash mode. Swipes must berepeated within 2 seconds.• In any mode, after a 3 second delay, swiping once willturn Off the STS™ Headlamp.HIGH MEDIUM FLASH1x1x2x2x 2 SEC 2 SEC2 SEC 2 SEC 3x3xTo operate VARIABLE DIM Mode:• Swipe once to enter High mode (left for White LED orright for Red LED).• Immediately press and hold anywhere on swipe padto enter Variable Dim mode.• Light will dim down and blink once when lowest dimlevel has been reached; then dim level will increaseto highest level.• Release hold when desired light level is reached.1x1xOKOKORTo ENGAGE LOCKOUT MODE:• STS™ Headlamp can be placed into Lockout mode toavoid accidental operation during storage ortransport. Headlamp must be in Off mode to engageLockout mode.• From Off mode, use two fingers to press and holdanywhere on swipe pad. Red LED will blink once.• Within 1 second, swipe in either direction. Red LEDwill blink rapidly for 1 second and then Headlampwill enter Lockout mode.• In Lockout mode, swiping in either direction willcause Red LED to blink rapidly for 1 second and thenturn Off.To EXIT LOCKOUT MODE:• With two fingers, press and hold anywhere onswipe pad. White LED will blink once.• Within 1 second, swipe left for White LED or swiperight for Red LED. This exits Lockout mode.• If no swipe is made within 1 second, STS™Headlamp will remain in Lockout mode.• If you forget how to exit Lockout mode, remove andre-insert batteries (following instructions below) toreturn to Standard Operating mode.<1 SEC1x 1 SEC 1 SECLOCKOUTMODE!1x 1x<1 SEC<1 SEC1 SECLOCKOUTMODE!NORMALMODE!1xNOTE: Interaction with the STS™ Interface surface requiresboth the interface surface and swiping finger to be dry. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine